Series 3 Exhaust manifold to downpipe 3 hole

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Georgeblade

Georgeblade

Active Member
Posts
139
Hello,
I've git a 2.25 petrol with a 3 hole connection between the manifold and exhaust downpipe.
Its blowing at the joint, but I can't find whether or not there is a seal available or required for this joint.
Does anyone have experience of changing this type of exhaust and whether there is a seal required?

Many thanks.
 
As above, no seal required. I changed this, bolted right up taking care to tighten the nuts (get correct brass ones) evenly. Bear in mind depending on the age of the Landy there are two different versions of the nuts with imperial and metric threads. Getting the old one off was a faff as odd nuts (including a Nyloc!) had been used. Patience, winding the nut in and out a bit at a time, and copious quantities of Plusgas meant I got them all off OK.
 
Mik87 said:
As above, no seal required. I changed this, bolted right up taking care to tighten the nuts (get correct brass ones) evenly. Bear in mind depending on the age of the Landy there are two different versions of the nuts with imperial and metric threads. Getting the old one off was a faff as odd nuts (including a Nyloc!) had been used. Patience, winding the nut in and out a bit at a time, and copious quantities of Plusgas meant I got them all off OK.
Click to expand...

I have a box of brass exhorst nuts in the garage somewhere ... :oops: still ...
 
You must log in or register to reply here.

Similar threads

W
Series 3 Land Rover series 3 knock
Replies
1
Views
213
steve2286w
steve2286w
dominicbeesley
2.25 exhaust manifold with 2.5 inlet
Replies
0
Views
842
dominicbeesley
dominicbeesley
G
Coolant temperature sender Series 3 2.25 diesel question.
Replies
5
Views
433
Guidoma
G
N
It time to sell !
Replies
9
Views
1K
miktdish
miktdish
L
For Sale NEW SPARES - MAINLY SERVICE PARTS
Replies
2
Views
897
Litch
L
Back
Top