Engine lifting brackets

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P38guy said:
O.K, so what would be the best way to remove engine make lifting brackets ? and can engine and gearbox be removed as one unit I have the use of JCB to lift out any advice appreciated thanks
Click to expand...
I'm planning to get the engine and box out of my spares dog in one piece, but I'm not worried if I have to cut the front of the car where the rad went:eek:
 
I have an adjustable lifting frame that goes on the engine crane. You can wind the lifting eye back and forth along it to balance the load or to tilt the load. Very handy piece of kit.
 
i have lifted a few of them engines out some of them have an eye just above the starter and onto the front of the exhaust manifold. that will give a pretty good balance. i lifted one by the 2 manifolds . remove all rads and coolers if the engine sways it cant do harm if they are out of the way . do not use inlet manifold for lifting if it is plastic
 
seanmull said:
i have lifted a few of them engines out some of them have an eye just above the starter and onto the front of the exhaust manifold. that will give a pretty good balance. i lifted one by the 2 manifolds . remove all rads and coolers if the engine sways it cant do harm if they are out of the way . do not use inlet manifold for lifting if it is plastic
Click to expand...

Thanks for the info will give it a go, it's coming out :)
 
You must log in or register to reply here.

Similar threads

B
Series II - Spare Wheel on Bonnet... HOW?!
Replies
12
Views
620
Boarder101
B
Mark Piercy
P38A It's a bit cold🤔
2
Replies
31
Views
3K
Datatek
Datatek
T
L322 Gearbox shifting problems
Replies
11
Views
1K
TrustyBib
T
S
Cylinder Head leaking smoke
Replies
10
Views
719
Saxpg
S
T
SIII swb88 '72 Rear engine/gearbox mounts seriously out of alignment
Replies
11
Views
523
tottot
tottot
Back
Top