eas electrical help please sorry

hello to all if I start where I can possibly make sense ,yesterday i lowered to floor suspension so i could repipe cruise with new pipework and took off under dash cover and sent drivers seat all the way back to make room and repiped and replaced all covers and this morn finished all work since then rangie wont raise but its showing no faults on laptop at all just flashing light as if its trying to raise but somewhere it wont let it
pump is pumped up to pressure but wont release pressure so this made me think is there a stuck valve but I don't know where got underseats stripped and pushed all connectors but still nothing (but unsure what ones im really touching

god I should have left it alone this weekend but its to tempting to play with it

any help thank`s
nick

Have you tried running the engine and leaving a door open for 10 minutes??

This will freeze the suspension and give the compressor a chance to fill the air tank if it has drained due to a leak....

Then close the door and send it up to standard ride height and see if it raises. If not, then check the compressor output.

Saint.V8 said:

Have you tried running the engine and leaving a door open for 10 minutes??

This will freeze the suspension and give the compressor a chance to fill the air tank if it has drained due to a leak....

Then close the door and send it up to standard ride height and see if it raises. If not, then check the compressor output.

Click to expand...

+1.

I will go and try that now and let you know what happens
thanks for reply

hi saint v8
got it working
(hurray thank`s to replie`s)
I run for 10 mins and then shut doors and tried whilst it still didn't work I then went to compressor and found compressor switching on and off for a second or 2 every now and then after a tinker around found wires and connectors are failing and so I think a rewire in that area is required with some new connectors if I find a decent new connector heavy duty one
so can I thank you very much as I would have carried on ripping out the interior until I needed a new rangie just got replace everything now inside if I remember where it all goes hehehe

ace people you all are and helpful to us mere useless one`s that try hard

thank`s saint v8
tomcat for added reply
you are gem`s

just test drived and all good now and also me cruise control works great as well so im a happy man now
I piped my cruise control in copper as I didn't want any future problems with it ,it works at 30mph and hold`s continuosly
thanks nick

thegasman said:

just test drived and all good now and also me cruise control works great as well so im a happy man now
I piped my cruise control in copper as I didn't want any future problems with it ,it works at 30mph and hold`s continuosly
thanks nick

Click to expand...

How much vibration is that pipe likely to get?

none cus I slid lots of rubber little sleeves on it and strapped it to foam shield and sleeved through into behind dash and then kept it all away from any other part
I was cautious of this and thought about it, but it has no vibration and no chance of deteriating now,

thegasman said:

none cus I slid lots of rubber little sleeves on it and strapped it to foam shield and sleeved through into behind dash and then kept it all away from any other part
I was cautious of this and thought about it, but it has no vibration and no chance of deteriating now,

Click to expand...

Nice. Haven't got cruise on mine and I think the dozel is electronic but I think I would try your fix if I had a V8.

Awesome...well done chap!

Grrrrrr said:

Nice. Haven't got cruise on mine and I think the dozel is electronic but I think I would try your fix if I had a V8.

Click to expand...

Yep Diesel CC is done via the EDC.