discovery td5 radiator drain
- Thread starter gazzab
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hedgehog70
Active Member
- Posts
- 161
- Location
- Leeds
Drain plug is in coolant rail under car just beyond front bumper. 13mm socket, if you undo this make sure you have a new washer.
Otherwise just disconnect top hose, radiator hoses and heater hoses and get flushing.
Remember it is a 50/50 mix of OAT coolant and water. Bleed thoroughly as per RAVE.
T
Otherwise just disconnect top hose, radiator hoses and heater hoses and get flushing.
Remember it is a 50/50 mix of OAT coolant and water. Bleed thoroughly as per RAVE.
T
HI HEDGEHOG
is the washers a problem and if i do remove drain plug will i then be able to flush just by removing expansion tank cap dont really want to cause air locks etc just going on a 600 mile trip so would like to have enough coolant in car with cold weather expected? this is my first td5 so any full advise would help i have bought oat red antifreeze so will this be ok?
is the washers a problem and if i do remove drain plug will i then be able to flush just by removing expansion tank cap dont really want to cause air locks etc just going on a 600 mile trip so would like to have enough coolant in car with cold weather expected? this is my first td5 so any full advise would help i have bought oat red antifreeze so will this be ok?
Jezath
New Member
- Posts
- 157
- Location
- cwmavon, port talbot
ive drained my system afew times using the same washer, no leaks yet...
For draining system undo expansion tank cap leave a rag over the opening to stop crap going in there and undo drain plug on bottom near front bumper, if you still have your undershield fitted then theres an access panel there you have to open first
For draining system undo expansion tank cap leave a rag over the opening to stop crap going in there and undo drain plug on bottom near front bumper, if you still have your undershield fitted then theres an access panel there you have to open first
Jezath
New Member
- Posts
- 157
- Location
- cwmavon, port talbot
on filing up follow rave instructions as previously stated.. these are a nightmare for airlocks
Hedgehog70
Active Member
- Posts
- 161
- Location
- Leeds
I would leave the drain plug alone and just disconnect hoses I said before. Then flush away into all the pipes you have disconnected and the header tank. Nice low pressure for 15 mins
Red OAT is the stuff 50/50 with water. I always warm the mix before adding it just to speed things up
TONY
Jamiedc
Member
- Posts
- 50
- Location
- Isle of Wight
hi tony just attacking this one now myselfI would leave the drain plug alone and just disconnect hoses I said before. Then flush away into all the pipes you have disconnected and the header tank. Nice low pressure for 15 mins
Red OAT is the stuff 50/50 with water. I always warm the mix before adding it just to speed things up
TONY
taking the drain nut out is not an option for me as it is in solid and the faces have worn so I'm going to disconnect the hoses.
is this all laid out in the rave?
