Discovery 2 lower hub ball joints!!!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
No, my local garage did all 4 for me recently, sorry. They did recommend genuine Land Rover ones. You are referring to the ones for the steering knuckles, the ones which can only be replaced 3 times before the axle casing is scrap? :( :(
 
If you've got the proper puller they're no harder than any other pressed ball joint, if you don't then they're a bit of a pain as the part where the puller goes isn't flat
I made mine out of so scaffold pole
 
I've got the same puller it's just getting round to doing it as I can't notice it when driving :p
 
You must log in or register to reply here.

Similar threads

F
Discovery 2 front drive shaft leak
Replies
12
Views
458
Anaconda
A
D
Disco 2 She lives again - also, advice for lower suspension dust covers
Replies
2
Views
325
Interceptorxj
Interceptorxj
Georgeblade
Disco 1 Tie rod ball joint torque setting
2
Replies
37
Views
2K
kevstar
kevstar
F
Disco 2 MOT failure
Replies
14
Views
568
frank1093
F
H
MOT Failed
Replies
3
Views
504
Datatek
Datatek
Back
Top