Buckhandle
Active Member
- Posts
- 247
- Location
- Denmark
Hi there,
I just recently replaced my rear x-member, having o cut all wires going through the frame. unfortunately I did not do the cutting, thus having no 'memory' of the wires were connected.
Now I am re-soldering (re-connecting) all wires and realize I may have lost track of a few wires.
Coming from the rear, I have the two wires (white/green) for which I only have one wire coming from the front of the frame. I assume that the two from the rear could be soldered together with the one from the front. I am hoping/assuming that somehow the three wires were cut in a joint.
But worst case could be a forth wire had snapped somewhere in the frame in an area I cannot see ..
Any suggestions or recommendations?
- Lars
I just recently replaced my rear x-member, having o cut all wires going through the frame. unfortunately I did not do the cutting, thus having no 'memory' of the wires were connected.
Now I am re-soldering (re-connecting) all wires and realize I may have lost track of a few wires.
Coming from the rear, I have the two wires (white/green) for which I only have one wire coming from the front of the frame. I assume that the two from the rear could be soldered together with the one from the front. I am hoping/assuming that somehow the three wires were cut in a joint.
But worst case could be a forth wire had snapped somewhere in the frame in an area I cannot see ..
Any suggestions or recommendations?
- Lars
