Copper banjo washers

Hi anyone know the part number for the ip banjo copper seals??

Cheers

esr354 ,i rarely change then as they never usually leak

I used the old washers when i did my engine change and its difficult to start 1st thing in the morning so i'm looking to change them and the injector washers too.

Cheers James

unless they are leaking diesel out then there not an issue ,injector washers will show leakage if you squirt some water or thin oil etc around there locating holes ,id be looking for air getting in wet around leak off pipes or filter,lift pump back

The banjos aren't leaking so i'll check round the injectors - the leak off pipes do look old so i might change them all the way back to the ip.

Thanks for the info

Anneal your old ones...

I use Dowty Seals mostly.

Oldseadog said:

I use Dowty Seals mostly.

Click to expand...

They look the biz. Do you know what sizes are required for fuel leak off washers and injectors? I have a small but persistent leak on one of the fuel leak offs. I think I might have a tiny leak on one injector.

discomania said:

Anneal your old ones...

Click to expand...

Worth a shot. Just get em red hot and allow to slowly cool.

I seem to remember that you heat them to red, then quench - opposite to steel.

sp00k said:

They look the biz. Do you know what sizes are required for fuel leak off washers and injectors? I have a small but persistent leak on one of the fuel leak offs. I think I might have a tiny leak on one injector.

Click to expand...

just buy some err1304 washers and a length of new 3mm rubber leak off pipe

Think the leakoff copper washers are M6

flatlander said:

I seem to remember that you heat them to red, then quench - opposite to steel.

Click to expand...

Copper can be annealed either way.

When it's heated though, it's a good thing to keep the heat for a short while, a couple of minutes or more, before quenching in air (slowly) or water. Allows it all to normalise ...

jamesmartin said:

just buy some err1304 washers and a length of new 3mm rubber leak off pipe

Click to expand...

I've replaced the washers but not the pipe. Thanks for the suggestion.

Hi daz , I have leak off washers and injector washers if you need some mate. I just changed all mine and got a pack of 20

cam300 said:

Hi daz , I have leak off washers and injector washers if you need some mate. I just changed all mine and got a pack of 20

Click to expand...

Nice 1 mate - i'll let you know - cheers

If you still have my number just give us a bell and il drop some off .

Yep still got it mate

flatlander said:

I seem to remember that you heat them to red, then quench - opposite to steel.

Click to expand...

Either for non-ferrus. If you can twist it in your fingers you have done it!