Britpart rear bench seat fitting.

Hi guys,

I've got a rear bench seat ready to fit up, except, there are two brackets included and i don't know what they do! They are about 2mm thick and 4 inches long, kinked in the middle at around 45 degrees. There are two bolt size holes in one half and the other is solid. Sorry there are no pics!

Also not sure how the seat base cushion is meant to attatch and there is no retaining device

Thanks in advance for any help

David

the two brackets bolt onto the back of the seat with the 45 degree angle bit pointing up and away from the back of the seat, these then slide upwards into the slots on the body tub holding the back in place.the cushions dont secure.

They don't fit at all,, or mine didn't, I just Modified them to fit.

Ahhh brilliant, thanks Nuisance the cushion doesn't get secured!

It can be a nuisance to get those little brackets to slot into the holes in the side panels - I found the easiest thing is to do up the bolt nearly tight, so that you can still rotate the bracket a bit to get it into the slot once the seat is in position.

I just secured the cushions to the frame with cable ties.

as above...the brackets are ****ers...one side just flopped about so i modified it just before i was about to weld it & it stayed there!