Lairdruss
New Member
- Posts
- 5
- Location
- Redditch, Worcs
A bit more info on this - I'm driving a 2000 Disco TD5 which I've had for about 3 months, came with one key and the switch went in the fob, as I'm not particularly a dab hand at soldering and after some research I bought some referred fobs off ebay. Now I know the procedure bellows unlikely to work as I'm not using the original fob but I though I'd give it a go anyway just incase I saved my self a few quid:
"1. Ensure ignition is OFF, dors unlocked, bonnet switch closed.
2. Ensure procedure from 3 to 9 is completed within 8 seconds.
3. Switch Ignition ON
4. Switch Ignition OFF
5. Lock Doors and Unlock Doors
6. Release Bonnet Switch
7. Switch Ignition ON
8. Switch Ignition OFF
IIf alarm is set, horn will sound and LED with light. Now programming of
plips can be completed.
10. Press and hold down button on Plip until LED flashes.
11. Repeat for additional plips.
12. The Dash LED will extinguish if both plips have been programmed
successfully."
Now I'm aware I probably need someone with Nanocom so I'll end up having to pay something, but I've found that when I get to step (5) above I can only do this from the button on the dash, when i press the button down on the drivers door sill it won't activate the central locking, and I then can't pull it back up, I have to use the button on the dash. So question is: Have i found my self a central locking problem? Should I be able to central lock all the doors from the drivers door sill? and should i be able to pull the sill button up?
Any point terms would be good and if anyone in the Redditch/Birmingham area has a nano com or similar that could be used to program the fobs, I can offer cash or beer. Thanks
"1. Ensure ignition is OFF, dors unlocked, bonnet switch closed.
2. Ensure procedure from 3 to 9 is completed within 8 seconds.
3. Switch Ignition ON
4. Switch Ignition OFF
5. Lock Doors and Unlock Doors
6. Release Bonnet Switch
7. Switch Ignition ON
8. Switch Ignition OFF
IIf alarm is set, horn will sound and LED with light. Now programming of
plips can be completed.
10. Press and hold down button on Plip until LED flashes.
11. Repeat for additional plips.
12. The Dash LED will extinguish if both plips have been programmed
successfully."
Now I'm aware I probably need someone with Nanocom so I'll end up having to pay something, but I've found that when I get to step (5) above I can only do this from the button on the dash, when i press the button down on the drivers door sill it won't activate the central locking, and I then can't pull it back up, I have to use the button on the dash. So question is: Have i found my self a central locking problem? Should I be able to central lock all the doors from the drivers door sill? and should i be able to pull the sill button up?
Any point terms would be good and if anyone in the Redditch/Birmingham area has a nano com or similar that could be used to program the fobs, I can offer cash or beer. Thanks
Last edited:
