any tips on removing seized injectors guys?

As the title says, i'm trying to remove injectors and there all stuck fast so looking for some good tips before i try again in a day or 2.

Thanks folks.

Leave everything connected - squirt copious amounts if wd40 around the injector bases. Leave over night. In morning start engine and warm it up to normal temp. Switch off! Then disconnect everything but leave the fuel pipes attached to the injectors but losses then and swing the pipes up out of the way.

Get a small Jemmy bar and a piece of thin flat Ali it plastic. Put Jemmy under the injector fuel nut with plastic or ski underneath do protecting the plastic on the head.

Next while applying a little pressure on the bar tap the fuel nut left and right do moving the injector. Keep at it and the will pop out eventually unless you are very unlucky.

The key is the hot engine as it softens the gunge and seals.

Hope this helps

plus gas Plus Gas Dismantling Spray (220ml) | Frost Auto Restoration Techniques, or similar will do a better job than WD40

Thanks mate.
Problem is i have most of engine apart as am removing the blown turbo so can't start engine.
i've been out and soaked in wd40 but the bleedin things arn't budging an inch.

thanks richard.

Ah didn't realise - here is a video -no use to you now but someone may stumble on this who hasn't stripped the head off.
http://www.youtube.com/watch?v=E88DhZGCat4

In your case I would use a hot air gun to warm the head up then do as I did.

Watch the plastics if you use a hot air gun

diesel is much better at creeping into gungy /seized areas/rusted areas than wd 40

diesel.. ok, hot air gun.. will see if i can get one.
With weather as it is i probably won't get to it for a few days, plus need to get 90 back together, but these are great ideas being stored up.
Keep em coming folks,

so do your best to get it soaking in diesel whilst it awaits your attention.

Are you replacing the injector's or swapping them into a donor engine???

Remove head cut neatly into four, then they fall out

Excellent advice!!! Might have to try that one myself........ Don't think my customer's wallet's would appreciate it though tee hee hee!!!!!

just removing in order to get plastic head casing off in order to get down to remove turbo.
Might put back in after or most likely replace with new dependent on costs.