Richarddiscoverytwo
Member
- Posts
- 93
Advice wanted about to identify part of cylinder head
- Thread starter Richarddiscoverytwo
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve's P38 RR
Active Member
- Posts
- 716
- Location
- Suffolk
That's to restrict the water flow, I'm pretty sure it goes in one end of the fuel cooler.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
int it a life sized model of Ratties willy???
livers
Well-Known Member
- Posts
- 3,906
- Location
- suffolk A12/A14 junction
It is a steel rule.
Richarddiscoverytwo
Member
- Posts
- 93
@Steve's P38 RR...that makes sense ... I think you could be right. Thank you that helps.
@redhand. Ermmmm, perhaps but will take your word on that lol
@livers...damn, I wondered where the tape measure had gone
@redhand. Ermmmm, perhaps but will take your word on that lol
@livers...damn, I wondered where the tape measure had gone
Richarddiscoverytwo
Member
- Posts
- 93
Forgot to say, this was correct - it was part of the fuel cooler. Thank you again. 
