thealarmingman
New Member
- Posts
- 8
i have a problem in as much as intermittantley the ABS light stays on when i pull off from cold start up...if i stop,switch off and start again and pull off it turns off as it should....any ideas guys....T.I.A
ABS Light
- Thread starter thealarmingman
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
chrisarvor
Member
- Posts
- 24
get a diagnostic done
its easy just someone with a laptop with the software
tells you whats wrong
its easy just someone with a laptop with the software
tells you whats wrong
thebiglad
Well-Known Member
- Posts
- 7,387
- Location
- Central France
Do search on here for abs blink codes. There is a way of diagnosing the problem using a paper clip and counting blinks.
SpaceDawg
Active Member
- Posts
- 935
- Location
- Cowfold, West Sussex
I agree get the diag done, I had the same problem and I had to replace a sensor on the front before it went away.
I wonder why LR did not put a Turn ABS off, its a complete nightmare system and with an Auto off road it make it real fun, grr.
I wonder why LR did not put a Turn ABS off, its a complete nightmare system and with an Auto off road it make it real fun, grr.
thebiglad
Well-Known Member
- Posts
- 7,387
- Location
- Central France
To disconnect the abs for off-road work just pull the electrical connector feeding the abs pump.
discool
Well-Known Member
- Posts
- 13,513
Could be as simple as a sticking ABS warning relay, IIRC there's 4 involved with the whole system. The Haynes manual will tell u what and where they are.
Does the ABS lamp go through it's test sequence when the ign switch is first turned on?
