Wanted 217522 pto dog gear

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Davemack

Active Member
Posts
119
Location
Hereford
Looking for some hens teeth.
A 217552 pto dog gear for a series land rover.
It's the part that slides to engage pto off back of gearbox.
 
Yes fairey series pto winch

Exellent winches.
What I did was fit a self aligning plummers bearing block, and fixed said bearing block assy to the nearside of the chassis, been on their approx 10 years.
The only real difference this makes is, you need the shafts sliding joint between the pto and the plummer block to alllow for engine movement.
 
Set of pics, I had to use the penny washers to space the block out as the chassis is er bent!
The biggest issue I can recall is the shaft running past the flywheel housing as it is very very close, if I did it again I would make a bracket for the plummer bearing rather than bolt it to the chassis, Iirc the shaft is 3/4 inhc dia.

Screen Shot 2021-09-26 at 07.47.20.png
Screen Shot 2021-09-26 at 07.48.13.png
Screen Shot 2021-09-26 at 07.50.36.png
Screen Shot 2021-09-26 at 07.51.04.png
Screen Shot 2021-09-26 at 07.52.30.png
 
Its been sat onmy bench since i first posted on here.
Ill get it bolted on this summer hopefully, thanks for pictures its helped a lot.
 
If you
Its been sat onmy bench since i first posted on here.
Ill get it bolted on this summer hopefully, thanks for pictures its helped a lot.

If you do some searching it appears some people run the shafting in different inclinations, sure I have seen pics of the shafting fitted higher and lower around the engine.
There is a guy on the s2 forum who knows a lot about the fairey winches, cannot remember his name but if you join (foc) and ask, someone will point you in the right direction.
He had an grey 88 s2 with a soft top and lived out Kings Hill way.
 
Back
Top