Injector 4 feels seized in place

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Obi_110

Active Member
Posts
69
Afternoon all - I'm looking to get my injectors rebuilt at the same time as my fuel injector pump.

3 of the 4 injectors came out fine, but the 4th injector (right at the back of the engine) is not budging - it feels properly stuck in place.

Are there any techniques you can recommend to getting these loose? Is there a risk it's seized in the cylinder head?

Thanks in advance
 
Tighten the clamp back up on it, then undo clamp 1/4 turn at a time and spin the engine over - repeat until it'll come out

or

slide hammer encouragement ...

Lol, no fuel pump attached at the moment, so no turning over option for me, and I
Tighten the clamp back up on it, then undo clamp 1/4 turn at a time and spin the engine over - repeat until it'll come out

or

slide hammer encouragement ...
Can't turn the engine over, removed fuel pump for rebuild 😒

Any recommendations on slide hammers?
 
My number 4 took an age to get out, by an age I mean days of driving it with the injector clamps loosened off to allow it to move.
As you do not have that option, I suggest a few drops of diesel daily down the side and hope for the best in a week or two.
Spanner on the flats sometimes works.
You can get special tools to remove the stuck injector, but they are not cheap.
 
Well, I managed to get injector no.4 out of the cylinder :D I thought I'd share how I approached it, in case it helps someone in the future.

-- Continual soaking with diesel didn't seem to do anything, so instead I went with a healthy dose of crack it freeze spray on the injector at the top, immediately followed by a dose of the penetrating version of WD-40 - theory being it might have just enabled a little bit of lubricant down.

-- Quickly upgraded from a standard 15mm spanner to a large 12 inch adjustable spanner which sat around the injector more securely.

-- Purchased a "spanner extender bar" from Amazon - had no idea they existed, but best £30 I've spent in some time. Enables you to get more torque on a spanner

-- Also purchased a cheapy injector puller from Amazon for £20.

Releasing the injector consisted of soaking, then very gentle but consistent clockwise torque to begin with, then soak, then turn. Then heavy soaking and leaving alone.

Eventually the injector started to rotate fairly consistently, and after about an hour at it, I noticed at one point a slight change in the amount of resistance. I was desperate, so I gave it a little bit of anti-clockwise motion, then clockwise again and then there was a little bit of easy movement - hey presto, injector puller on and out it came.

I suspect I spent 5 hours on this, 3 hours spread out from my original post, then 2 hours last night. Ironically, the injector puller, while useful at the end, I could have probably managed without - the spanner extender was the winner here. And I did this with the cylinder head still on the block, there's no way I could have secured the cylinder head and applied as much torque as I was initially without it still being bolted on.

Photo of the little darling, the tools used, and my celebratory beer afterwards :vb-drink:

20230802_202223.jpg
 
Slide hammer is what you need, make one yourself... just something threaded onto the end which lets you move a weight (big nut) and bang it out....
 
Back
Top