Search results

TD4 Auto ..relocating Bailey caravan weighing 1400kg ..... was pretty good and very stable but 400kg lighter would have been spot on :) It was within the vehicle specification, but pushing it on the recommended 80% guidance

Have you checked that the intercooler upper rubber hose isn't rubbing through on the engine cover

Now would be a good time to get a second key :)

Can be grit particles or loose fittings, but mine tend to go because the missus plays loud rock music and blows the cones You may also find water damage to the cone as it is in a door

I can only confirm that on my FL1 Dec 2000 TD4 ..... 01MY with the ATE MK20 ABS system that the grey adaptor isn't needed. After 01 I believe they went to the MK25

Yep ..my Hawkeye covers 3 types ....the Wabco used on the earlier Freelander and the ATE MK20 and MK25 used on the approx. 2000 up FL1s Current price £240 inc VAT from Island 4x4

I thought the Hawkeye covered these .....it has the Wabco Modulator on the list when you plug in to do a reading.

Mine - Year 2000 TD4 Low pressure pump is in the tank ...also has fuel level sensor and line for Fuel Burning Heater supply. Much easier than under the wheelarch And readily available for about the same money new rather than risking a takeoff

I had to drill my sensors out of the hub, even then it was difficult !! Haven't been on here for a couple of years. Laid up the FL whilst moving houses a couple of times and being stuck with the 3 amigos even after replacing sensors and getting good ohm readings on the connections, I'd got a...

Did you fit new VCU support bearings and align them ?

They are metric not imperial Get yerself one of these :- Irwin 5pc Bolt Extractor Sets by: Irwin - UKtools Limited - Hand Tools : Power

Have you got a towbar with 2 connectors? That looks like power sized leads for caravan plug in.

Had mine done a couple of months ago, I had fitted new bushes, droplinks and wishbones with new ball joints. Plus 2 new tyres (on the back) I had it done at ATS - the guy took an hour lining up the rear first, then the front ..all on a connected computer screen. It was within acceptable...

They are later ones from a TD4 - so they will fit early or late.

If you have an early TD4 like mine - it ain't there ...nothing near the handbrake at all. But I did find something that looks like it should be that ...next to the brakelight switch by the steering column - has the right coloured wires going to it.

Sent you a PM Awaiting reply to the above

Reckon £50 the lot, collected. They have used Michelin Synchones on that need changing. I was gonna put some chunky tyres on for the Winter, but ended up putting Pirelli Scorpions on my 16" rims instead.

Yup :D I have a set of 5 Alloy 15" rims going for a reasonable sum from a TD4

Nor mine (2000 TD4) - but I found it up next to the Brake Switch by the steering column.

I have used one with success It has been on there 2 years through 2 MOT's Though it must be done with care