Search results

This but it can also have a Brake servo failure switch in series with the Pressure differential warning actuator.

Thanks, it is a 3/8" BSF thread then, its definitely not 15mm diameter!

Folks, Can anyone confirm the thread used on the Oil Pressure switch a Series 3 2 1/4 Petrol engine (3 main bearing). I believe it to be a 3/8" B.S.P. but this is assuming part of the P on my die has worn off as it looks like an "F". The thread looks anything but "fine" but the only other...

"No results returned" is what comes up when I check my '69 Series and old tractor so I think your good.

I did but unfortunately I only found the actual hand throttle and link to the main throttle linkage but not the final arm that goes on the existing throttle linkages which I believe is the part you are after. I have the same parts as in this ebay ad (this isn't my ad I just saw that it had the...

I have the parts for a hand throttle somewhere in my shed, I'll try look them out, might be a few days before I find them though.

One of the wires will come from the coil and the other may go to a capacitor on the side of the distributor. Any shorts would need to be fixed so I'd definitely start there. The wire from the coil connects to the points inside the distributor and, when the points are closed, to ground through...

Thanks for sharing, the tractor looks pretty weird! Has this home made job been seen here before? http://retrorides.proboards.com/thread/179016/land-rover-tug

I replaced my brake master cylinder on Friday but had the Air Suspension Inactive, Hot Dog Controller Inactive (that what HDC stands for right), ABS, Traction control and Brake warning lights all come on afterwards. Only got to investigate today but eventually found the brake pedal switch...

oooh didn't know about that one, cheers!

Changed the rear brake pad wear indicator yesterday. Found another one of the previous owners wee ditty's; they'd used a 80mm long, fine threaded bolt, to hold the bottom of the mud flap on.... thank goodness it sheared off! Also anyone changed the brake lines on a l322, will I want to torch...

I'd take a tenner for it, that would cover postage, will PM you.

Found the fuel filler today (while looking for something else) This is what it looks like: No chain to stop the filler neck extension but a loop in both parts to tie it down. Any use (if you are still looking for one)??

mind if I ask a trailer "noob" question, what exactly do the brakes on a "braked trailer" consist of? I've had trailers with brakes that operate manually on the handbrake and with the emergency brake away cable that'll pull the handbrake on if the trailer coupling brakes, is this all that you get?

sorry, cannae find the bits in any of my hiding places.

eee well so far I cannae find the damn thing, will have another look tomorrow

Hi, I have a stash of 83 series 3 parts including a filler cap like the last link, not 100% sure what the filler neck is like but it was different to my 81 series 3 I had previous to it, will dig it out a get some pics, see if it is any use to u.

Went to overhaul the front brake calipers this morning as one had seized. Turned into a proper ball ache as a previous owner had rounded off the caliper mounting bolts, the bleed nipple was rounded off, the disk had a lip preventing the pads from sliding off easily and finally the piston...

'] Me on Saturday, "seems legit, I'll take it". its in for an mot today!

I've spent Sunday, Monday and a couple hours yesterday cleaning my newly purchased rangie, this thing is so minging! Still got the dash, roof lining, passenger seat, engine bay and underside to do. Highlights have been a blood stained hand print in the boot and a spare wheel well that was full...