Search results

As title says..... Has anyone tried one of these plates. I thought they may help with manifold warp. They resist thermal transfer between the head and manifold lowering EGT. Thermal Inlet Gasket - Ferriday Engineering I know the link says inlet manifold, but they are available...

In Rave it says there are marks on the camshaft, which line up with the cam carrier. This lets you accurately set full lift on each injector when doing the bump adjustment. This is a new one on me, as I've never seen them. Has anyone seen these marks and possibly explain where to look.

Having issues with disco at minute and could do with some help. New engine and engine wiring loom, Egr removed. Idle a bit lumpy and dips as if I've got a bad earth. Earths checked and appear ok. Nanocom showing Egr short circuit, Egr stuck closed, Air flow circuit current, Temp...

I've got the pistons out of my TD5 at the moment, engine stripped but still in vehicle. I'm replacing the rings and big end bearings. Has anyone done the the main bearing shells, whilst the crank is still in (ie rolled the shells in)? I was going to replace the mains whilst I'm in there, but...

Checking the engine pulleys on my Td5 and found the Ace pump hard to turn. There was also some play in the pulley when moving forward and back. has the pump had it?

Hi all, Just changed the head on my Disco and had a quick question. When I was replacing the long bolt which screws into the side of the head and tensions the chain, I noticed two shiny grooves on the end. The end that presses against the tensioner guide. I want to know if this is normal...

Hi everyone I'm new to both Land Rovers and the site, so please excuse my lack of knowledge. Recently acquired a td5 Disco 2 auto. I've had a vibration when the auto box changes gear, which is usually around 2500 revs. I thought it was a transmission fault at first, but after searching and...