Do you identify as something else? A washing machine perhaps?
Are you sick and tired of being expected to be rough and butch due to your gender?
Had enough of Brut wearing biker types constantly wanting to buy you a cold one?
Drawing the line at 'putting the boat in the water' and 'firing up the...
My and the wee man have tried sleeping in the landy out on greenlanes and its just not going to happen, he loves camping and I hate camp sites, so Im thinking wild camping with a tent and trying to get a green lane that might accommodate this? I was thinking peak district but anywhere closer to...
any brown laners spending a day this week end driving it deep into the brown?
up the brown creek , down the brown gully then back up the brown groove back road?
a good long day in the deep brown shuk perhaps?
a swift slither through the sloppy brown byway?
or even an afternoon of touching...
19j, drives Ok, then when its warmed up it lacks power and shudders under load, ok if I tease the throttle, give it beans and it shudders. Thats a fuel/air issue, right? No smoke though. Its the lack of smoke thats puzzling me.
It just cuts out for a second or two when driving, on the odd occasion it surges, sometimes changing gear throttle release is slower.
Usually, when its been driven a while this all clears up.
It needs a filter so Im going to start there.
19j, makes a horrendous noise, when stationary it's bad, not so bad the faster I drive, my first thoughts were pas pump, Pas works but not great, also, how interchangeable are the pumps?
Its not leaking, but its an old brass one, so its ancient. My guess is its original (1985). Are the new ones better? Would there be better output with a new one?
No the clocks, you know the shelf bit? I want to fit some low wattage leds in there that come on with the side lamps so I can easily grab things from there at night,
I had one of these in the shed and I fitted it but its just way too bright.
Any ideas?
WOW - 1X 4X 6 LED 12V 10cm Flexible 5050...
That time is coming, they say to remove the intermediate gears and replace the crush spacer, is this totally necessary to get the correct preload on the bearing shims?