Search results

He says he does:) On the subject of calibration of eas my wife bought me a 3d Printer and I have a file to print a set in ABS or Carbon Fibre so that is on my to do list.URL-https://www.thingiverse.com/thing:2523860

Thanks to Wammers and Datatek for your help. Finally got around to checking connections and found corrosion on pin 2 on ecu. However, I have now found I need a new height sensor on the osr which I am going to have fitted by my local garage. I will report back again when it is done. Thanks...

Thanks Wammers and Datatek I will check those points tomorrow and update the forum

Lamps start normal then flash until the car moves then they go permanently on, text on dash says eas fault, no slow 35mph

no, none of those just a load of xmas lights on the dash. it seems to be operating normally?????

with the original the fault was intermittent but now it is permanent, I am going to put the old unit back and see how that goes

Hi keith, I don't know if I can see live readings on Hawkeye, I will check and report back, corrosion sounds like a possibility however

I have a 'Hawkeye' fault code reader that showed the fault as real left height sensor. it could not remove the fault so i bought a new unit from Island 4x4. However, when the local garage fitted it ( he did seem to know what he was talking about and mentioned calibration) it came back worse...

Hi Gents, I have a problem with a rear height sensor. Bought a new one (dunlop) and sent it to the repairer who does most of the work on my rangy. He fitted it and it is worse. I spoke to Sam at Island 4x44 and he told me it is most likely a wiring fault so I wondered if any of you Gents had...

Just noticed water running into the passenger footwell any advice please

Panic over!! local indy fixed it for a tenner

diesel filler cap wont come off. There is a cracking noise as I turn it. All was ok last time I filled it any ideas?

Hi Rasheed, I am having similar problems. Did you get your sunroof sorted, if so, what was the problem and how did you sort it? all the best enery8

Hi Keith, You are right about the motor drive. I dropped the motor and run it but the cog did not turn. Ordered a replacement from roverviews and it was here pdq, took less than an hour to fit. All good now.

Hi Keith, I have the switch pack off and it would appear that the switch is all enclosed and I cannot see a way to remove the cap in order to access the contacts. Do you know if there is a way to pry the top off the switch? I can open and close the sunroof with the sunroof key so that would...

thanks Keith I will have a look at that but it is not working either way now but I can try a different switch.

Hi Guys, not oened the sunroof for ages but today when water ran into the passenger side footwell my first thought was it chucked down last night maybe the sunroof drainage pipes are blocked. Pressed the switch to open the sunroof - nothing no slide, pressed the other way tilt worked then when...

Thanks Keith, I will investigate that and give it a try

having searched the records and failed I thought I would ask you knowledgeable gents if anyone has changed the clock in a P38. is there a simpler way than described in the workshop manual? thanks in advance.:rolleyes:

My uncle used to do that way back in the mists of time-always worked!!