Search results

For Sale SOLD Demand Sports Silencer for TD5 90, to fit standard system. £190.00 (£252.00 rrp). Demand Engineering Link for full spec.

Check my listing on ebay... item No.224236999481 Collect from GL20 Only done 30,000 miles, so plenty of life left in these parts. Dual Mass Flywheel Clutch and pressure plate Also Clutch master cylinder and pedal + new TRF master cylinder Clutch lever and release bearing - good no noise when...

ALL SOLD I have listed on EBay the following: No. 222843491344 - 5 x Steel Disco 1 wheels with 205/80R16 tyres in good condition No. 222843513882 - 5 x Steel Modular wheels with 265/75R16 General Grabber AT2's No. 222843531962 - 4 x Deep dish alloys with 235/85R16 General Grabber TR's No...

Searching around for the cause of my limited performance, and suspected the MAF... so had a look and... should there be two sensor wires in this picture? I managed to snap off the guard, hence my ability to get a slip of paper behind the sensor for clarity! Note that this is also a cheap...

I managed to get an abused performance intercooler of the Bay, had it repaired, and got around to fitting it last weekend. Found this sludge on the outlet side on the intercooler... inlet side was just a bit of oil - as usual. I had flushed it out over a year ago - could it be a bit of moisture...

Anyone going? Hopefully it will be a bit bigger this year... I will go for a look as it is just down the road for me... and sure I will spot something else I didn't know I needed:)

I have just fitted a pair of diff guards, of the skid plate/wrap around type, and am a little concerned with the rear one: 1. Brake line actually touches the top plate - should I sheath the brake line with something similar to the breather pipe/pvc pipe? 2. When looking back under the vehicle...

I am considering a trip to Montenegro, and am looking at the option of sticking the Landy on a train from Dussedorf to Vienna. The idea of avoiding hours of boring motorway - not the ideal territory for a defender - and making progress while asleep appeals... as a better use of my limited...

Next one is due for 4th October... Anyone going... let us know if you're selling - 90 rear headlining... or QT diff guards??

On the quest to convert a 90 into a camper for two! Just wondering if seat riser rails will enabel me to push the drivers seat back far enough to fold flat - after removing the seat base? Have any of you with these seat risers ever tried this? I have an early TD5 with the single stem...

As this now merges Eastnor and the Bristol and West shows it should be a good one. I'm going on sunday, as its the auto jumble day :-) See you there ?? Malvern Land Rover Show & 4x4 Spares Weekend | Mark Woodward Classic Events

Just done a quick search, and couldn't find an answer: Will TDCi differentials fit earlier (TD5) vehicles?... I assume they are 24 spline and same 3.54:1 ratio.

Whilst under the car replacing a leaking diff seal I noticed the starter motor was very 'damp'... and drips on the air intake hose... I had replaced the fuel pressure regulator about 1000 miles ago, and that was clean as a bell... further investigation: Oil seems to be coming from below the...

So I fitted a new pattern part about 3 months ago... had the weeping hole! Now checking my diff levels and noticed the weeping hole again :mad: I have attached a photo of the failed unit... looks like the grease has been pushed through the bearing... all O rings look OK and appear to have...

£380 4 wheels have DynaBeads to improve balance. All in perfect condition, not used on anything other than turf or tarmac. No splits, cuts or cracks. Modular rims are offset - not sure how much - but they didn't rub on my 90. 4 miles from M5 Junction 9.

Anyone going to the LRO Show next weekend... any chance of a lift?... or share the fuel cost with me?

Anyone tried these from Mud Stuff? Their only £35 for a pair... might solve the problem of mud splattered door handles and windows associated with wider tyres... I know a few have complained of this...?

I'm heading off to Pembrokeshire this weekend and fancied passing along Pendine beach... give the dog a run and possibly check out the Museum of Speed... Googled... but nothing up to date on access to/from the beach for vehicles... if there's any up to date knowledge out there, I'd appreciate...

My pump died last year, and I have finally got around to pulling it apart to see what went wrong, or see if I could revive it... and swap over the sender unit so my fuel gauge would read true. I remember Shifty saying that you could clean a gauze filter on the bottom of the pump, so removed...

Anyone going this year? I'm having a fundraising shed clearout, so have booked an outside plot... if anyone in the Tewkwsbury area wants to share the cost and sell some stuff, I've got a spare seat! I may be able to borrow a trailer if you've got a load to sell... could meet/load up on Sat...