Search results

Hi all, just had my driver's door main latch mechanism replaced for my MOT. Got the car back on Friday and the car now unlocks and immediately locks and does this over and over again. The driver's door isn't locking unless I push the button down, doing this isn't activating the other doors. The...

Urgent Help, my wife's D2 V8 was running perfectly last week. We've spent a lot of money replacing the engine and having some preventative welding done. As of 2nd Jan it will crank but won't start. Battery was replaced yesterday 8/1/24. Turning the key the the battery light is on and the check...

This has been annoying me since I bought her in 2005/2006. Speedo was converted from KPH to MPH. Odometer is still KPH but clock is now MPH. Problem is that when stationary the needle only sits at 7mph instead of 0mph as its lowest point. Therefore my indicated speed is approximately 7mph faster...

I'm at my witts end!! I had the local garage seal my rear tilt & slide sunroof permanently shut with tiger seal and it has rubberised gorilla tape over that but the water is stll getting in. They won't take it back in and try again unless I pay again. Any suggestions would be greatly appreciated.

Wanted complete headlining for a D1 300 V8 manual tilt and slide sunroof car with front trays with sunvisors. Would need to be couriered to Aberdeen or be fairly local.

Hi guys, finally got my leaking sunroof fixed. I'm looking for a good D1 300 body headlining for manual sunroofs. Will need the majority of the plastic trims pieces. I'm in Aberdeenshire, is there anyone local(ish) that has one or is there anyone who could securely package & courier it up...

Morning all, The wife's beloved D2 V8 (known as Lulu) is sick. Depending on the diagnosis on the from the mechanic - I might be in the need of a good low mileage Thor 4.0 V8. Anyone got a running engine (if required). Pictures and videos would be appreciated. Thanks Craig

Anyone got a NOS or really good condition STC1284 master cylinder ABS for a Discovery 1 V8. Don't know if the new Britpart version is any good

Can you fit 110 front springs on the rear of a D1? They look the same as my current springs but slightly more up to the job. My car sags on the driver's side at the rear. I know rear 110 springs can be fitted but with a little modification. (That's the eventual plan) Thanks in advance

Hi guys need some help and advice. My handbrake lever base plate snapped (see second picture) in half. I want to know where the bolts are located on the underside of the car so I can replace the lever. I can't find any information or pictures showing where the bolts are located. The handle end...

Hi guys, my wife had an off on black ice on Friday. Looking for a pre facelift grill in Niagara Grey. Can anyone help? Would need posted to Aberdeen. Thanks Craig

Guys, I need advice/help. Had a replacement y-pipe with cats and new lambdas fitted. When I now start the car it immediately revs to 3000 rpm for a few seconds then stalls. All that's been replaced is the exhaust. Any ideas? SWMBO is getting annoyed.

Rare Original Land Rover OEM Soft nudge bar for Discovery 2 Facelift. 99-04. No fixing bolts. Postage is available at request and at buyer's cost. Can be collected from Aberdeenshire. One of the covers has had a previous repair but doesn't affect Spot lights are available for £20 extra...

Anyone got a good second hand Y-pipe with cats for a 3.9 D1 V8. Would need posted to Aberdeen. I actually bought a new aftermarket one online and it's not fit for purpose. Thanks.

Quick question. My 98 D1 V8 has a just had a new generic Y-pipe with cats fitted and lambdas for MOT.. It passed. But the car is now struggling to accelerate and select gears and it's vibrating when engine is on. Feels like it's making too much pressure in the exhaust but also feels restricted...

Does anyone have a set of D2 V8 front springs standard height. - Had a set of TD5 fitted but they lift the front of the car. Would need to be posted to Aberdeenshire.

MYL4X4 BLACK TUBULAR BUMPER DISCO 1 RRC REALLY GOOD CONSTRUCTION. HAS BEEN PAINTED WITH HAMMERITE. BUT NOT AT ALL FALLING APART IT'S A SOLID PIECE OF EQUIPMENT. ORIGINALLY WASN'T CHEAP. IDEAL FOR A OFF-ROAD PROJECT OR AGGRESSIVE LOOKING DISCOVERY 1. I'M SELLING AS I'M RETURNING MY...

Has anyone got a working set of Discovery 1 front bumper fog lights with all wires and plugs. Mine have finally died. Thanks Craig.

Looking for a pair of front bumper support brackets - returning to a standard front bumper but my support brackets on the wings are corroded, does any have a clean set that I could use? Will need posted to Aberdeen.

Looking for a standard D1 (300) front bumper with fog lights & headlamp washers. Would need posted to Aberdeen.