Search results

Must have been swapped as I have range rover diffs. Have taken half shaft out and done it. Thats all oils changed and all nipples greased. Come on winter!!:)

Not on rear pan, not a sals axle either

I am slowly working through changing all the oils and greasing all the nipples. I am at the back last job is to replace the rear diff oil. I cant see the refill plug, what am I missing? Its looks like a standard rover diff and according to Haynes it should be on the drivers side fron of the...

Thanks for the replies guys

Hi I have a really good series 3 with a 300tdi fitted. the front standard leaf springs are corroded together so make the ride bone jarringly bouncy. I have already fitted new standard leaf springs to the back which seem to have flattened so the rear is lower than the front. I am considering...

Meant to say wet freelander?

If you have a factory sunroof wind it back and look in the corners of the undertray for small holes. The holes drain into the wheel arch IIRC. No need to clean factory sunroof seal as it is designed to let water through to the undertray. If aftermar ket the probably no drain holes, wash and...

Just thought I'd give something back to members. I used to work as a windscreen and sunroof fitter many years ago so when I brought a Freelander that was constantly misted up/wet inside this is what I did: Water leaves a white trace where it is getting in to the car. You can put UV die into...

Just thought I'd give something back to members. I used to work as a windscreen and sunroof fitter many years ago so when I brought a Freelander that was constantly misted up/wet inside this is what I did: Water leaves a white trace where it is getting in to the car. You can put UV die into...

I sent my turbo for reconditioning as the seals had gone and bearings were worn. I was quoted £100 over the phone but when they got it and stripped it they said it needed loads doing and it would cost £360, about the price of an off the shelf refurb. I got another one off interweb with no play...

Thanks Lynall. I'm going to do major surgery today - head gasket and water pump so whilst in there I will remove it and 'recycle it'. psb

I suspect I'll get an answer to this quite quickly. My 300TDI conversion uses an injector pump with what looks like a motor housing next to the diaphram on the top of it. There is a plug with 3 wires, brown, green, black. The block is stamped 18L which means its an EDC engine yet the pump has a...

Thanks Lynall Its on the to do list for this week

Hi all. I have a 300TDI fitted to a series 3. Only had it a few weeks and have been concentrating on getting it through an MOT (Passed). When cold if I accelerate above all but a crawl it knocks. This goes when its warm but re appears under heavy acceleration. So when driving it I can't benefit...

1.8 02reg with aircon. need cooling control unit. This one has 4 plugs coming out of it, one for each fan, one for power, one for sender ecu. locates on fan cowelling. Anyone got one for sale?

Thanks ianda12, I'm gonna download the rave disk thingy today

2002 Freelander 1.8 GS A/C. Took it for MOT, while revving it up for emissons the bloody thing started to boil. Luckily HG does not seem affected. Fans not kicking in. So I have read up on it via Haynes manual. Got new temp sensor coming as I hope this is the issue having read on this site the...

I have just brought an 02 freelander, same problem. I checked the carpets prior to purchase so know the heater is ok. When I were a lad I used to fit aftermarket sunroofs. when (not if) they leaked the best thing was to smear vaseline on the rubber seal to repel water and revitalise the seal. It...