Search results

I have a Series 2A 1969 with a 2.25 petrol...next to the coil I have two ballast blocks...one says "K 19" and the other says "K 22"...which one should I use? Thanks Guys

Hi everyone...I have a Series 2A 2.25 petrol that misfires when hot. We rebuilt the distributor a few days ago...reset the points, checked everything...cleaned it all up pretty and it run like a stallion for 2 days...now she is back to her old ways. Cap is new, points are new, condenser is new...

Not sure, but my petrol carb is actually TOO HOT to even touch when sitting in traffic or not moving very fast. Its starts bucking and sputtering like I am getting vapor lock. The manifold as you all know is attached to the intake (which I maintain was a bad idea) and the heat causes the...

Hi Everyone, I have a fuel gauge that only goes up half way. I put in a new sending unit in the tank. To test it, I grounded it out so the fuel gauge itself went promptly up to full. Cleaned the grounds, cleaned all the contacts at the dash and tank...and with a full tank, it only goes up to...

Someone told me that plastic grills were a Series III only item...as was the rounded hood. Thanks

Does anyone now of a company who makes limited slips for the Series Land Rovers...I love the design of the Detroit TruTrac because it contains no clutches to wear out, but they only offer later Land Rover units. Thanks

Hi Again, Well when I got my transmission apart it wasn't a II or IIA, but a very early III transmission. My truck according to my local Bangkok parts dealer tells me it might have been one of the earliest heavy duty upgrades for 1969 and might explain the curious "D" at the end of my VIN...

Hi everyone, I will be "cooking" in a large aluminum pot over propane. If anyone has any formulas that will eat iron and aluminum down to bare metal, please share your secrets. Also, will I or should I use a rinse when they are "done". Thanks

I have my gear box apart and want to know if there is a proper way of determining if the bearings need to be replaced or not. Sight inspection is only good for visual deterioration, lesser forms? Or does everyone just simply put all new bearings in?? What is an approx. price for a complete set...

My question is, can I remove the double top on my roof without having the nuts drop onto the back side of my soft bonnet on the interior of my truck? The flat head screw tops are accessible from the top with washers and rubber washers but are the nuts "fixed" to the inside main roof? or do I...

My question is, can I remove the double top on my roof without having the nuts drop onto the back side of my soft bonnet on the interior of my truck? The flat head screw tops are accessible from the top with washers and rubber washers but are the nuts "fixed" to the inside main roof? or do I...