Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. martin c brown

    clutch

    Hi all I am having problems with my clutch on a land rover discovery 2 it makes a noise when the engine is cold I think it may be the thrust bearing I also had problem with gear change difficult to get in and out of gear after a long run
  2. martin c brown

    Toque

    Hi all I would just like to thank you all for your support over my Landy rear rebuild she now back on the road. I have one question driving her on the road is fine,but she looses speed very quickly going up hill or on a long incline. She is as standerd with cat and egr system only because I...
  3. martin c brown

    vin plate

    Hi all Does any one know wihch is the best way of replacing the rear chassis vin plate next to the fule filtter on the chassis rail, as i am intending to take the car to spain and register it there later this year. has any one been down this road ? Thanks
  4. martin c brown

    Cooling

    Hi all I have now ordered a new brake master cylinder so I hope this fixes the problem. I have been doing some more work on the old Landy she is nearly ready for an MOT I have noticed next to the oil filter just to the right is a rubber bung with a clip on it. I think it is part of the...
  5. martin c brown

    Brakes

    Hi All I have a 2004 discovery I am having problems with the brake bleeding, I have bled the brakes over and over but can not get them to hold up. Every time I put my foot on the pedal it goes down to the floor. I can not see any air bubbles when bleeding I have read this forum for advice...
  6. martin c brown

    Rear air bags

    Hi all And thanks for the info you have passed on so far, I have a problem with the rear air bags not inflating I have check fuses and check pipes to the bags all ok But with all the doors closed engine running I can not fell the compresser running. Will or should the compresser run with the...
  7. martin c brown

    Engine steam cleaner

    Hi All Does anyone know if it is possible to clean the engine and gearbox of my disco in situ ? I have some leeks from hoses and would like to find out where the leeks start so I can fix them mostly around the gearbox and lower part of engine. Or a good way of cleaning it may be with gunk and...
  8. martin c brown

    ACE BLOCK

    HI I am having trouble with the ace block,to start with I have replaced the rear ace pipes as the old ones were bad an very rusty. Now I have come to the block I have removed the old seals only to find that the ports are very corroded, putting in new seals with all the corrosion will only end in...
  9. martin c brown

    Axel

    Hi The rear axel on my discovery 2 has a leak but not from the hub or brakes I have it off the car and have cleaned it and can see oil coming from around the weld I can not see a crack,but after a few hours a small drip of oil is there, can this be welded up has anyone done this to stop the...
  10. martin c brown

    Disco 2 running bad

    Hi w My 2004 disco td5 has stared to run uneven like it is running out of fuel, when pushing down on the accelerator black smoke comes out, can anyone help ? a few years ago took out the EGA system and put in a bigger inter cooler and had it rechipped been OK up to now
  11. martin c brown

    Tow bar

    Hi to all I have a Land Rover discovery 4 and would like to fit a towbar and light to it does any one know if there is a kit you can buy and fit yourself I will need to tow house box and plant trailer so the standerd tow ball that comes with the car is not much use any help would be great...
  12. martin c brown

    Air horns

    Hi I am trying to wire air horns to my disco 2.I have read that you can wire them by using the original wiring from the horns is this the case? I have wired them using a 4pole relay from the battery. using pin 87 to the + side of the compresser and the - to ground earth. pins 86 and 30 I have...
  13. martin c brown

    Prop shaft

    Hi to you all. So that I can take my time fixing the front prop shaft Is it ok to run the Land Rover with out it. It's a TD5 2003? Thanks martin Martin
  14. martin c brown

    TD5 prop shaft

    Hi to you all not been on for a some time I hope all is well in these new times. I have a 2003 td5 and the front prop has gone I think it needs new spider joints but not sure does any one know if there is anyone out there that has recondition ones on the shelf ?. As don't have time to fix it as...
  15. martin c brown

    Disco 2 engine mount change

    Hi has any one changed the engine mounts TD5 I have a 2004 model and the engine shudders on startup and when I tune the engine off it has been doing this for some time now it makes the hole car shudder any ideas?
  16. martin c brown

    Steel wheels

    Hi there Does any one know where I can get some 18" steel wheels for my td5 as the alloys leak air I have herd that vw fit but not shore with type would fit I don't won't to put 20" on as this would make the car wonder on the road :confused:
  17. martin c brown

    Clutch

    Hi My 2004 TD5 has only done 66k but when driving her along the clutch slips a little when accelerating. I have noticed the the gear change is hard to engage after driving for a while at around 70 or 80 mph, on long runs on motorways but if I stop for coffee say 20 minutes or so it seems ok...
  18. martin c brown

    Poly bushes

    Hi there Has any one fitted poly bushes to a td5 and does it make a differens to the ride at the moment my Landy seems to drive ok as you would expect it to the only thing is when you tune off the engine the car shakes this was picked up buy The chap at the MOT station that I went to any ideas...
  19. martin c brown

    Remap

    Hi there I am tacking my TD5 disco for a remap tomorrow I have done the EGR removing and fitted a larger inter cooler but have left the cat in place as I read that it would be an MOT failure if I do that the car is a 2004 do you think it will be ok with the cat in place not sure what BHP I...
  20. martin c brown

    Santana

    Hi there I have a long wheel base series 3 1979 Santana and I need to get hold of the rear lights lenses for the driver side does any one know where I can get this from? as I have been looking around with no luck I have tried all the sites for series land rovers and eBay Here is a picture...
Back
Top