Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. mmajor2

    Steering guard

    So I’ve been trying to refit the steering guard to the Landy this morning after many years of it gathering dust in the back of the garage. It used to fit just fine, however I now seem to be having clearance issues since lifting the suspension by a few inches. The guard is fouling on the steering...
  2. mmajor2

    Speedo Cable

    Evening all, Been ages since I have been on here due to having to put the 90 on the back burner for a while. I've just got a quick question about speedo cables, I currently have a broken 2-piece cable in my 200tdi conversion, what i want to know is, will a 1-piece cable be a suitable...
  3. mmajor2

    Exhaust Studs

    Hi guys, im in the process of switching out the turbo on my 200tdi discovery engine but i need to replace 2 of the studs. The first is one of the ones that go to the exhaust manifold which is an M8x35mm, and the second connects the turbo to the downpipe which is M10x50mm. the only problem is I...
  4. mmajor2

    Castor Corrected Radius Arms

    Hi folks, Just a quick one, does anyone know of anywhere that will bend existing radius arms in order to correct my castor on my 3" lift. I just dont want to have to shell out for a brand new set! Cheers in Advance!
  5. mmajor2

    Starter motor wont stop spinning.

    Hi folks Went to start the 90 this afternoon and it started up just fine, but then i noticed this noise...the starter motor was still spinning, it wasnt engaged but was still on. I turned the car off and the engine stopped but the starter was still spinning away. I killed it with the...
  6. mmajor2

    Salisbury Plains

    Alright folks, I'm heading over to Salisbury this weekend. been there a few times before although i've always been following someone else and forgotten to take note of where we have been. Can anyone give me a few grid references of some particularly good bits, some of the places we went...
  7. mmajor2

    Not another oil leak!

    Hi guys, I the process of taking my 200tdi out in order to change the clutch but whilst its out I figured I might as well see if i can sort this oil leak out too. Has anyone had a leak like this before or could tell me the cause? Would be good to get whatever parts I need here before I pull...
  8. mmajor2

    200tdi fuel system will not bleed.

    Ive got a 90 with a discovery 200tdi conversion. ever since beening at a rather extreme angle whilst laneing the other day it is no no longer driveable due to having no power. it will idle fine but as soon as you apply any load to the engine it will give up the ghost and stall out. I am...
  9. mmajor2

    Rocker Cover Pressure

    Been suffering with this problem for a while now but been too lazy to sort it out. Oil all over the rocker cover and rest of the engine for that matter. its pushing up and through the oil filler cap. when you remover the cap you can feel hot air being blown up and out. if anyone could shed...
  10. mmajor2

    Pas Fluid

    Just a quick one, does anyone know how much pas fluid a 200tdi with a 4 bolt steering box requires? If just replaced the box and the system is pretty much empty.
  11. mmajor2

    Wheel Studs

    Right so i've got a d-reg 90 and i've had to replace the wheel studs, i bought a set of 5 wheel studs, part number FRC6137, however when they arrived it turns out they have 41 splines on them as opposed to the 31 splines on my current studs. Does anyone know the correct part number for wheel...
  12. mmajor2

    Part Number

    Does any one know either the part number, or at least just the name of the little orange plastic clips that are attached to the gearbox tunnel and other floor bits that are used to screw all the panels together. Cant for the life of me find any anywhere because i dont know what to search for!
  13. mmajor2

    Battery Box

    Hi guys, got my seat box in pieces at the moment as it needs a bit of a rebuild. i was just wondering though, the battery box has quite a few pre cut holes in it. Obviously if im wading water is just going to be flooding in through these, is there a reason they are there or will it be alright to...
  14. mmajor2

    Series Seat Box

    Does anyone happen to know if a series seat box will fit into an early 90. I'm not to worried about the transmission tunnel arrangement but are the width height and depth measurements the same? Just trying to figure out the cheapest way of repairing my knackered one.
  15. mmajor2

    Bloody rot!

    So after pulling the seatbox out today to make life easier when removing the gearbox, amongst doing some other bits an bobs, it transpires that the bottoms of the door pillars where the seatbox and sills mount are pretty badly corroded. seeing as its ali im not really sure the best way of...
  16. mmajor2

    Just a quickie

    Hi guys, just a quick question, should there be any gasket or seal in between gearbox extension housing and transfer box for an lt77? i couldn't remember what i took off when the old gearbox came off and cant see any in my parts catalogue
  17. mmajor2

    Gearbox issues

    So i'm driving home from work this evening and as i lift off the throttle in second gear a knocking noise starts coming from the transmission tunnel. strangely it doesn't seem to happen in every gear, but it does in the majority. Everything appears fine whilst at idle and accelerating and even...
  18. mmajor2

    Brake Light Fuse

    I am currently having to change my brake light fuse every couple of weeks. although cheep and easy to do, this isnt exactly ideal. does anyone have any thoughts as to what might be causing this problem? i assume its a short of some sort but no real idea where to start. has anyone had a similar...
  19. mmajor2

    Theft-Proofing Defender TILT

    Hi all, After finally saving up enough money to fit ANOTHER (first one i had fitted was stolen after 5 days!!) Tilt to my 90, i was hoping you'all could be of some assistance in helping me ensure this one doesn't go walkies as well. I have already sort the assistance of a friend to weld the...
  20. mmajor2

    Lifted Suspension Steering Guard

    After fitting a 3" lift to my 90, the steering drag link from the drop arm to the left hub now rubs on my steering guard as i corner or undergo any sort of articulation. has anyone else had this problem? If so, is there a company that makes steering guards to suit lifted fenders, or does anyone...
Back
Top