Search results

I think that's if you're looking to replace the whole crossmember..

I did it 5 years ago when doing the floor and it wasn't much fun, this evening Ive just disconnected the feed and return pipes, fuel intake and breather pipe without issues. From what I remember it's now just a few bolts underneath and the fun moving it with 1/4 tank of diesel in!!

I'm patching up the forward facing side so don't think pulling the bumper will help

Have started disconnecting the fuel tank ready to drop it out tomorrow hopefully that will allow me to access the full rear side of the crossmember..

Or maybe not :( If I unbolt the crossmember mounts can I raise it a foot or so higher than the chassis?

Thanks looks like I may be able to get in by removing the bumper

Thanks I have a replacement bush, the current one is poking out slightly so presumably I can pull it out with some mole grips?

attached

It's been 5 years since I completely stripped the disco down and replaced the floor, inner wings, chassis mounts and anything else that was showing signs of rot, and the tin worm has come back.. What would be the quickest/easiest way to get access to the rear crossmember? I was hoping not to...

Ok blonde moment, have now lopped the heads off a load of 6mm bolts job done

ok thanks, a bit annoying as its only lasted me 18months

Phoned a few places it seems these are no longer available unless I buy replacement ABS rings for £250!! Looks like I will need to get some 6mm rod and cut it into small pieces - has anyone else had this problem? They must corrode pretty quick..

My rear propshaft coupling is starting to show signs of cracking, still has plenty of life left in it but I'm wondering whether it would get through the MOT. Does anyone know whether this would generally be deemed as a failure or not? Photo below.. Thanks

Thanks Discool, you sarcastic git!! :) But in all seriousness much appreciated, useful link..

Photos attached..

Can anyone help with a part number for the (5)stud bolts with 10mm nyloc nuts that attach the ABS sensor ring to the rear wheel hub on my '95 disco TDI ES? I'm struggling to find the code anywhere and need to get them ordered asap. Thanks muchly

So there should be no large air bubbles visible in the injector overflow pipes? Thanks

Engine running, intermittent buzzing from diesel pump http://vid258.photobucket.com/albums/hh256/graham22k/Mobile%20Uploads/IMG_7247_zpskh7p9zjf.mp4

Engine not running, constant buzzing sound http://vid258.photobucket.com/albums/hh256/graham22k/Mobile%20Uploads/IMG_7248_zpsdqgrpinx.mp4

The electric buzzing sound of a 300TDI diesel pump should this be constant when the engine is running? I ask because sometimes it's not on my '95 disco. With ignition on and engine not running the sound is constant, with engine running sometimes the buzzing is intermittent. I currently have an...