Search results

Hi Guys I will have to go to a dealer tomorrow. Thank you so much for all your help I will post an update when problem is resolved . Enjoy the great weather and mind how you go

Hi, If I lock the doors from the inside latch switch all buttons on the doors will close except for the drivers door button that vibrates up and down several times attempting to close

Hi , ya only the one key fob and 2 keys

Hi There, I have lowered the drivers door window so I can access the ignition Fob will lock the car but will not open it . The key does not lock or unlock the door .The internal door latch will not open the locks and the only way in is to disconnect / reconnect the car battery and start the...

HI All. Road side rescue has opened the bonnet ,disconnected the battery for about 2 minutes , connected back up and was able to open the locks. When I gave the car into the garage opening and closing was no problem so now I think would they have disconnect something while replacing the...

Hi Guys I had a new clutch fitted to my 04 Freelander 3 days ago and only collected it yesterday only to find the fob or key will not lock the doors. I cannot return to the mechanic as he has died suddenly and the garage is all closed up and may not re-open. I have pressed the fob button 5...

Hi There. I have a 2004 Freelander 1 and about 8 weeks ago my clutch pedal went to the floor, so I had the clutch master cylinder replaced with a new one .All went fine for about 3 weeks and then clutch went to the floor again. On the advice of the mechanic I had it replaced with a better...

Hi There, I had the same problem some time back and what worked for me was to screw back in the top part of the Glow plug a few turns . After a few days of driving the pressure in the chamber popped up the remainder of the Glow plug.You will know when this happens because it will sound like a...

Hi There, I have recently fitted Two new tyres to the rear of my Freelander 1 td4 and for the last few weeks while driving it sounds like there is a Propeller under the engine. I have swapped over the tyres front to back but only made matters worse so I have changed them back. I now have...

Thanks for your reply, The Oil I used is castrol magnatec 10w40, Will try the 2 stroke tomorrow and see does it help. Many Thanks.

Hi All, There is a tapping/ticking sound coming from the top of the engine TD4 , for the last few weeks and Yesterday I replaced the oil/filter added Wynns Hydraulic lifter treatment, drove it for about 10 miles and still no difference. Do I need to drive it for a lot more miles. do I replace...

Hi There, I went to replace the glow plugs in my freelannder today. When removing one of the plugs it came apart and the end part stayed inside the head. I tried to pull it out with a plires but failed to move it . Any advice would be helpful Thanks

Hi There, I need to remove the battery from the Freelander but I don't want the rear window to drop down when I disconnect it, How do I do that if possible. Many Thanks

Hi All Over the last few days my landy (Freelander TD4 2004 ) has being very slow to start. On a one occasion when turning the ignition all you could here was a click from the starter. after several turns the engine started. The live terminal on the battery is full of green powdery gunk ...

Hi Guys, Took the freelander td4 to a land rover dealer today and after a hour long check over Inc.test drive they said it was a bearing in the gear box.Mechanic told me to change the oil in the gear box and Inc a Gearbox treatment to QUIETEN THE BAD BEARING rather than rebuild the Gearbox...

Hi Guys, Over the last few Months there has beed a slight whine from the left side at slow speed. When I press down the clutch it goes away. Took it to the mechanic today to be checked out.After the test drive he informed me that its the front Diff. That needs to be replaced at a huge cost.The...

Hi There, My Td4 failed to start this morning, it turns over for about 3 seconds and stops I try again and it turns over for another 3 seconds and stops. If I keep the ignition switch in the start position it turns over a few times then stops ,turns over again then stops .Thil will continue as...

Hi There, I Recently had 2 new vcu/prop shaft bearings fitted to my 2004 freelander on inspecting them I noticed that the four large metal washers/seals that had come with the new bearings are not fittet . Should this be a problem Many Thanks.

I Decided to replace both fuel and breather filter for the off chance they might be clogged, Thanks for your help, will let you know how I get on.