Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Palagius

    Ace cafe land rover meet this saturday

    As above 11am
  2. Palagius

    Welder west cornwall

    Anybody know if or can recommend a land rover series savvy mobile welder in west cornwall, Thanks Ryn
  3. Palagius

    Carawagon

    Does anybody know wether the carawagon and sixpot association is still about,
  4. Palagius

    Bulkhead supplier

    I am weighing up my options as to wether to repair my bulkhead which is surprisingly good apart from a few areas on the right and left sides where it is completely rotten or to buy new, Any pointers to the best supplier and also the cheapest supplier would be most welcome, i am more leaning...
  5. Palagius

    1968 109 insurance

    Any recommendations for an insurance company for the above with a manned phone line, previously with my 88 i got tired of listening to music for 1/2 an hour on flux's customer service number and went with gallaghers via quoteline but atm i cannot buy online as they dont recognise my reg, Thanks
  6. Palagius

    88 to 109 chassis swap

    Is it possible to rebuild my rotten 88 2a diesel pickup onto a new galv 109 chassis and bulkhead, Richards have said that the shock/axle dimensions are different, is this a major prob?, if so could i just source and fit a 109 back axle?, i am replacing the wiring and brake lines anyway and the...
  7. Palagius

    gps speedo

    my series 2a 88 '69 speedo's needle fluctuates a fair bit and as i have smaller tyres fitted which affect the gearing i didnt want to be over or below 30mph in traffic etc , i bought something similar to this gizmo for £15ish,i hooked it up with a poundshop phone powerpack and it does the job...
  8. Palagius

    diff swap advice

    i will be fitting an experimental 3.54 rear diff fairly soon and would it be ok to use blue hylomar as a sealent on the mating surfaces?,, initially i am only fitting the rear as i want to see if i get on with the new characteristics before i commit to the full changeover, regarding the oil, i...
  9. Palagius

    transit engine with adaptor plate for series

    transit diesel with pump,starter manifold etc with milner adaptor plate for a series, bought from a local resto company who removed it to fit an original,was running well when removed,i rebuilt my original petrol so stopgap no longer needed. £275 west cornwall, help with loading available
  10. Palagius

    series 2a 88 engine refitting

    i have fitted new shells,pistons and rings in my old girl,when refitting the engiine using a decent hoist is it ok to fit the dizzy/fuelpump/starter etc pre fitting,i stripped them all off prior to removal as i did it by myself from a beam off the roofrack using a block and tackle so weight was...
  11. Palagius

    head bolts

    good afternoon, do the head bolts have washers?,when i took my head off to have the lead free work done there were none,i have seen head bolts for sale and listed alongside are washers,if yes is there any reason why general purpose washers of the correct size could not be used, also on an iron...
  12. Palagius

    airgun forum

    on my gun forum somebody has posted that they have no heater and a puddle under the vehicle,their garage says it is just normal land rover territorial ****ing!, what is the likely source as all hoses are o.k?
  13. Palagius

    petrol safety series 2a 88

    when i got my series it had a very strong petrol smell inside,further investigation pointed to the filler to tank hose was well gone,i replaced this and the smaller breather tube along with proper clips at all connections, the smell went so that was sorted,on my modern van i have no hesitation...
  14. Palagius

    Dec '69 series 88 petrol station wagon for sale

    SALE ON HOLD
  15. Palagius

    Emissions bits

    Good afternoon, Is it possible to do away with this part and pipes and simplify the system, atb Ryn@wet and warm west cornwall
  16. Palagius

    Timing mark pointer,

    Good morning, I have bought a powerspark dizzy and leads etc,i was waiting for a chance to fit it and luckily my old girl started misfiring on overrun yesterday, I was half way through strobing it ( '69 2a/3.) and came to a bit of a problem ,I have a timing mark pointer which is not the same as...
  17. Palagius

    higher ratio diff

    good morning, I am thinking about fitting a higher ratio diff or pair off a later model to my series 2a/3,this is as I am mostly on the roads and lanes and only seem to use use 3rd or 4th gear and 50mph is about as quick as I go,it is more for mpg and comfort as it is revving a bit on the high...
  18. Palagius

    Compression and plugs

    Good evening,this evening i checked the compression and plugs, No 1 plug is a bit too rich and the others are good,maybe a bit towards lean,i had to do 2 tests on number one as to double check the odd psi,i have put a kn type filter on with a new coil,i have bought new leads + powerspark...
  19. Palagius

    Series 2a/3 topend noise

    Good evening,i hope all are well, After doing all the body and running gear work and upgrades on my 2.25 1969 88 petrol i have moved onto the engine, any suggestions or advice would be very welcome, All the best, Ryn
  20. Palagius

    On the road

    After a year of landy ownership i finally got to go on a trip last sunday,albeit to the petrol station and back, Ryn, Sunny west cornwall
Back
Top