Search results

Afternoon All - been a while since I was on here...not having the Landy as my daily driver any more has reduced the constant need for fettling to a far more relaxing and enjoyable occasional tinker ;) I feel that now might be the time to bite the bullet and really get to grips with the rot on...

Gents - back for more help… So, as you may have seen from earlier post, I have just had my oil sump off. Changed all the oils, replaced sump - no leaks; all good. Touched nothing else. Test drive and few minutes in this nasty noise appears. Gingerly bring it home. Thought it came from under...

Evening All - Quick question for you... took my sump off today for the first time after 10years and given it a good clean. Before I go to refit it, can I ask what's the latest thinking on sealing it up? PO must have used endless amounts of various seals, silicone and rubber judging by the crud...

Folks - would I be right in assuming that if the brake pedal now travels to the floor with almost no braking action apparent but there is no fluid loss anywhere, reservoir full, no bulging pipes that means my master cylinder has gone?? Servo assisted dual line system. No brake work been done...

Hello All - After 12 yrs or so of ownership I figure it's about time I try and sort my wipers... I've got an 1981 S3 which has a rotary 3 position switch (pic below) - with a push activating the washers. The PO had done some pretty weird and wonderful things with the electrics, most of which...

Hey all - going to be redoing my ignition timing in the next couple of weeks but before I do thought I’d see what advance is working best for you all these days. Previously mine’s always worked best with more than the book says - What degree of advance are you running at?? TS

Hello - Was sorting out my heater box on my s3 today and have hit a problem... Went to remove the adaptor that joins the heater pipe to the cylinder head (part 624091 )when instead of unbolting the bugger just snapped off! So now I'm left with part of the adaptor still threaded into the head and...

Hello all - am looking for your collective wisdom / advice on the best way to settle leaf springs before tightening up all the bolts. Have just fitted new rear leaf springs to my 109 and have so far just tightened up the u-bolts enough to hold the plate and spring in place to the axle and have...

Hi all - Having got a load of help trying to get my brakes sorted in my last post (https://www.landyzone.co.uk/land-rover/series-3-brake-pedal-master-cylinder-adjustment-please-help.340288/) I'm now turning to the experts again for more help! Longish story short, having adjusted and tinkered I...

Hello everyone - I'm new to this site but have come in search of help! I have a series 3 109 (1981) and can usually get the work done that it needs fine, but I'm struggling with something I think is so basic as to be embarrassing and am hoping someone here can help. Basically - I can't figure...