Search results

Hi all, With the restore of the Landrover 110 coming to an end, I wanted to add a Oil Pressure and Oil Temp Gauge. The issue I had I had no where to tap into the engine. I got the below manifold made with a high pressure pipe from the engine where the Oil Switch was located. This will in...

Guys, I'm just coming to an end of a 1984 Landrover 110 restore and I'm trying to figure out how I can secure or lock the doors. I'm dealing with the old lift door locks handles. I don't have a key for the old barrels that's in it. Can these barrels be got or what is my options for locking the...

Hi all, I'm looking for a little help or direction. I have a LT77 gearbox that's fairly tight and in goo condition. I have one small issue... When I put the gearbox into reverse, the reverse light comes on as it should but then goes off. If I put my hand on the gear lever and and apply slight...

I've picked up a pair of Mazda RX8 seats (Non Electrical) that I plan on fit in my 1984 Landrover 110. Can anyone confirm if a third RX8 seat will fit in the middle. That would leave 3 Mazda Rx8 seats in the front. I've two boys and to stop arguments I'm going to have to try and make two seats...

Is it possible to swap a engine and gearbox from a Discovery TD5 into a Landrover 110 which had the old 2.5 N/A. I have found a complete TD5 that I was going to buy and replace Loom, Use the TD5 ECU, Disco Gearbox.... Is this possible or what are the pitfalls. I'm struggling to get a 200tdi or...

Guys, I'm removing the 2.5 NA engine when doing the bulkhead, I'm also replacing the clutch when I'm at it. Can anyone let me know what else I should be doing a this time. What's seals should I be changing? Pity I haven't a 200/300 tdi to pop into it but... I do love my NA lump!

Hi, I'm looking to pick up a snorkel for a 1984 110 2.5 NA. I'm struggling to find anything out there that doesn't look like a drain pipe... Can you please point me in the direction of where I can get a snorkel suitable for this model? Many thanks P

Guys, I'm moving from Goodyear G90 on the original rim to a 16X8 Steel Rim with 265/75/R16 remold or heavy AT.... I'm only dealing with 67 horses (2.5 NA Diesel Engine). Can you give me the pros and cons please lads....

Guys, I sent the old 110 in for a bulkhead repair and was getting a respray also but.... It turns out the bulkhead was too bad to repair and it had to come out. It's now being replaced by a nice new shiny bulkhead. I also had a clutch that was... only okay, so it's now being changed also...

I'm looking for some help. Can anyone tell me which is the one is the temperature sender. I'm assuming it's the one between 10 and 12. If this is correct, what is the sensor between 12 and 16 and why do I not have a wire for it? My temperature gauge is playing up and the head is only have been...

Hi guys, Looking for some direction as to where to go / what to do. I've got a fairly original LR 110 2.5 NA hard top in good condition overall but it's a bit too... Well... boring. I know many of you won't believe this but... I've a bone dry engine. It was fully rebuilt including the pump...

It's my first post so please be gentle all. I've got a fairly original LR 110 2.5 NA Hard top in good condition overall but it's a bit too... Well... boring. I know many of you won't believe this but... I've a bone dry engine. The engine was fully rebuilt including the pump and the injectors...