Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    Freelander driveshaft advice

    Right ok thank you for simplifying it for me I’m still learning how do I go about that is that a gearbox back out job or can it be replaced with it still on ? And dose anyone know where I can buy a new bearing if you can buy them ?
  2. M

    Freelander driveshaft advice

    The gearbox support bearing you mentioned is this inside the box or ? Thanks for the advice on shafts really grateful I do know the n/s shaft is shot but not sure about the support bearing ?
  3. M

    Freelander driveshaft advice

    Where are thay located ? Iv had oil leak out before changed a driveshaft seal on the box and solved it but that was another box this one the n/s front driveshaft seems to be no good I can inspect more was I replace it along with the seal just don’t know if thay use different shafts and thank you...
  4. M

    Freelander driveshaft advice

    Hey lads finally got my auto gearbox changed on my td4 freelander but have very bad vibrations from driveshaft inner cv seems like it had play it’s letting out my atf fluid when you check it for play. So just gone to buy a driveshaft and thought is there a difference between the auto td4 and...
  5. M

    Help lost reverse

    True I don’t want to be pulling it off again thanks for all the help I’ll keep you posted How it goes.
  6. M

    Help lost reverse

    Also I believe the solenoid that’s out of range is used for gears reverse 2 and 4th from what I read but forward drive is smooth and pulls well in every gear without fault
  7. M

    Help lost reverse

    It shows on dash as r and the light is in correct position when in reverse when you put it in you get the slightest jolt very faint and the revs drop sometime you put you foot down after putting in reverse revs don’t respond straight away there’s like a slight pause then free revs other times it...
  8. M

    Help lost reverse

    Is that the low clutch solenoid I check all of the solenoids only one that was out of range was 2-4 brake duty solenoid it’s rage say 2.6-3.2 mine was at 3.3 every solenoid was in range as part from this one
  9. M

    Midlands meet

    Once my landy is fixed will be interested to meet other proud owners I’ll keep you posted
  10. M

    Help lost reverse

    Ahh thank you for that now I’ll put it down to that as it was rolling as it went in reverse and since then I did rev it and put it in reverse to see if it would kick it in to working but it didn’t obviously my first experience with auto. thank you for the help guys if any one has a guide or...
  11. M

    Help lost reverse

    Do you mean revved above idle while it’s in gear ? Sorry if I’m not getting last part clear
  12. M

    New member first landrover first problem :(

    Thank you for reply I did realise this and have already reposted in that section kind regards dave
  13. M

    Help lost reverse

    Hi thanks for the reply. I haven’t done any oil change with the box it’s been fine until it was rolling slightly and put in reverse oops since then no reverse iv read about the inhibitor but surely it would of been fine afterwards. I haven’t a clue. iv done everything on cars except welding and...
  14. M

    Help lost reverse

    Hey all I’m a new owner of a landrover freelander sport auto td4. Drives superb apart from reverse it tries then just revs like it’s in neutral. Tested all solenoids seem ok but the 2-4 brake duty solenoid is reading 3.6 sometimes my meter says 3.3 is this to high as I was told 2.6-3.2 is the...
  15. M

    New member first landrover first problem :(

    Hi all I’m dave from midlands. Recently got my hands on a freelander sport td4 auto 2004 drives beautiful but... it will not reverse it engages reves hold for a second then it feels like it’s in natural. There’s no fault codes except p0500 in pending that’s now been cleared. Iv tested solenoids...
Back
Top