Search results

Yes starting to think that it’s the acumilator not shore how long the abs pump I have fitted was sat off car for going to put my acumilator off old abs pump on tomorrow and see if that helps

Hoping to get mate round tomorrow will get him to look at that but it’s the same every time pedal pressed realy had enough of it now realy need this week have tryed ignition off and pumping 30 times to depressurise and can almost push pedal to the floor when ignition on its firm but still loads...

Yes it’s been repitadly blead in the exact order followed to the letter by me at least 15 times and my my mate about 5 times the last 17 times o air bubbles have been found

No clamps have been on it have brake fluid at all 4 wheels no air yes I have followed it to the leter several times over I have pumped over 4 L of brake fluid through it but still pedal feels soft and abs light pops up it stops fine abs pump working every pedal press

Yes know were they are had no fluid coming out of them on old modulator at all new one fitted have bread them several times over the last few days following every step to the letter good flow of fluid from all with no bubbles in sight

Yes both of them are done and air free yes back one is a pain to get to

On to my next issue started when I fitted new discs pads calipers on front went to bleed brakes on the order required in book no fluid would get to calipers same both sides side so replaced the modulator now I can bleed the brakes blead them several times now not getting any air start up and...

Tryed a different make o ring black one fitted and no leak at all running well now starts on morning better than it ever has done

Sorted it running nice now thanks for help

Done the leak sent u message as have it up and running but still have a issue and liking for some help runs and starts revs ok until it touches tickover then it won’t rev

Second attempt tomorrow striped it back down ready can only think it didn’t go in perfectly squere when I tightened it up but I did do each bolt a bit at a time trying to keep it all squere will have got some bolts with smooth shanks to use really gutted it’s not gone right tryed so hard with it

The new seal was green colour have tryed again today with another one checked all round pump and it was sat in grove nice cairfuly did it up so it went in nice and square and still leaking from there so it’s somebody it again Amy idias what am I getting wrong with it

ok seen the videos of how it is done tryed to do it yesterday with bosh seal kit got it all back together and it leaks striped it back down to find the new o ring destroyed have been told to use a viton o ring we’re to get one from and what size do I need to get

Hi we’re to get thevoton seal fro and what size plz