Search results

Anyone got any experience of these on a Series 3? Once this resto is complete I'll be using as shooting wagon and will driving predominently on the road. Other suggestions/recommendations welcome.

I'm trying to get my injector pump timing set up correctly but I can't seem to get the master spline on the drive gear to sit at 20 degrees. It either sits at 10ish degrees (pic) or if I rotate a one tooth it sits at 30ish degrees. The flywheel is set on the 13degree mark after passing TDC on...

I've tried to start my 2.25 diesel today after a long winded rebuild. The injector pump was professionally rebuilt in Sept 2020. I'm struggling to get the pump to prime. I've bled the fuel filter. Fuel cutoff is open. The vent on the pump body bleeds fine but when I open the vent on the...

I'm in the process of rebuilding my gearbox. When I tried to split the bell housing from the main case I struggling to get the layshaft out of the front bearing. I ended up pressing it out. I've replaced all the bearings and I'm now having the same trouble getting the shaft back into the...

Ordered a complete set of FloFlex bushes from Paddock and they are out of stock they can't confirm when they will be. Apparently, they've been waiting for delivery from FloFlex for over three months. They asked whether I wanted the Britpart alternative? I chose FloFlex as although more...

In an moment of amateur hour excitement I recently brought myself a scruffy but running Series 2/3 mongrel. The main reason for the purchase was to get my hands on the galvanised chassis to be used on another Series 3. Having become rather attached to this fine vehicle I had decided that it...

The engine block in my 1967 SIIa/SIII mish-mash is stamped with 99600840C. I've been trying to identify the engine from this number but can't find any reference to something beginning with the 996 prefix. I'd be interested if anyone could point me in the right direction. Thanks Rob

Can anyone give me a few tips for removing wheel studs that screw into the hub? Pic attached. Thanks in advance. Rob

I'm proud new owner of my first Landy, a 1967 2a. First job has been to strip the hubs down and replace the very manky bearings. I purchased a bearing replacement kit which included a plastic inner hub seal. I installed new bearings without a problem. I'm now struggling to get the seal to fit...