Search results

Hi. Another project I wont get round to. My lad for physical reasons cant use a manual.and iwas going to use this engine and gearbox in a series 3. But things get in the way and it wont happen. The body has been cut about and rusted and wont go on the road again but the engine and gearbox...

In another thread mentioned 3 amigos up again. Fault code directed myself to rear right Abs no voltage. Quickly checked the voltage on the wires up to the abs connector and it was 4.9v. Presumably 4.9v is in the right ball park. ? Going to now change hub and sensor.

Todays fault 3 Amigos. Fault 4067 . Broken wire . Low impedence. Rh rear Sure its the one i replaced with new hub / bearing and sensor 6 months ago. Could have been the left Brain a bit fuzzed. Something for next week.

Checked / changed my gearbox oil yesterday. First time in my ownership. Intention was to change oil. Run for a week or so and then rechange with filter. First job was a bit alarming due to lack of oil. No wonder the transmission heat light came up when on salisbury plain a couple of weeks...

Taken my rad out to wash out. Find that the bottom teo tubes are for the diesel cooler. One of these has a small preformed hole of 2mm. The other is completely sealed and looks like never had any opening. Is this correct. Recently repaired my diesel cooler it was full of muck. And so were...

Just spraying Salisbury plain mud out the rads of my disco 2. Noticed that the air con fan appears stuck. Can not rotate it with a srewdriver poked in. I am presuming there is no clutch like the compressor and should be free to rotate. Presume its just seized. Is my assumation correct...

Took my truck for a proper run since fixing the diesel cooler, and fitting a digital temperature gauge. First time that i had actually monitored the running temperature to such a precise level on any of my vehicles. Went on a run around the new forest in south Wiltshire ,Hampshire and...

My heated rear window had been blowing fuses and whilst i was fitting a remote temp gauge and coolant level sensor which required the removal of kick trim panels around the pedals decided to investigate. Armed with Rave wiring diagrams and connector drawings that had been advised the wise men...

Even though i invested in door trim tools managed to break all bar two on disco 2 rear door.? Anybody know the correct name or code or suppliers for these. 20 years old and think first time its been off. Must be the same for most of the range. Thanks.

Hi. My Disco 2 is losing a bit of coolant. Not too much and realise that in future some in depth work could be needed as its now done 160,000 miles. Cant obviously see where from at this stage. Not desperate but dont want to get caught out. In the mean time am fitting a temp gauge with an...

Disco 2. Think I know the answer after doing some reading and research. One of the jobs i was going to do later this year was drop my sunroof and seal up the leaking sunroofs. The previous owner had siliconed up. Today both keyfobs are working but not opening the car. I would presume that...

Need help guys and gals. Had to change my thermostat 3 to 4 weeks ago because of water leak between it and hose. All seemed good and with lock down and other vehicles not used much. Now With colder weather noticed that heater not seemed to be working. So checked thermostat in right way round...

In a seperate thread i have started the Cronicles of my 2a but i have a problem with my temp guage. It rises to just below the red. Sometimes just into but mostly just below. Does not seem excessively hot. It has a new sender and replacement instruments over the years. The regulator is new...

Just starting a new thread for my Series 2a. A few months ago after a 3 year restoration / refurb included some photos and details in the Introduction section. Thought time I should commemce its own thread as I have fun with it. And its first break down. Alternator packed up. So here goes...

Hi, Just starting to put a thread together for my discovery 2. After purchasing it in the summer have had some advice off this forum that's been very useful. (Hope I'm posting in the right section. My lad does not think i ought to be let use with technology.) Been over Salisbury plain in it...

Hi. Any body know if there is a readily available compressor guard for the Disco 2 to peotect it when the going gets tough. Yes. I know the answere to some would be to remove and fit coils but aiming to keep the air suspension.

I know that you guys have probably discussed this to death. But i need to confirm if my thoughts and learnings are correct. There are consideration with going away from standard of course. But trying to find initially what will physically fit a stanard D2 with no cutting or altering stops etc...

You guys will probably moan at this as its another amigo problem. But a question over hill descent light on my new to me Disco 2. The hill descent seems to be working , when on an incline in low range and in Drive with feet off the pedals the abs is working a good un. A constant chatter but no...

Been a member for a few years but have been quiet. I had some great help with my P38 which kept embarrassing itself. When it worked it was great but that was not very often. It embarrassed itself again just before I was due to go on a Battlefields tour with my daughter to France a couple of...