Search results

Gents, Bought some replacement Tail lights for my SIII SWB, The old lights only had two wires (and earthed through the light fitting) the new ones are plastic and have three wires, Can some one shed some light as to how to wire these? on the fitting I have Red/Black - which I have...

Hello mate, I have not dealt with the aerial hole yet, I’m thinking I may use it for a CB radio Whip, I was going to integrate one into my rig somewhere! Just haven’t worked out where yet!!

thanks Rich, yes they are Exmoor trim canvas cards!

So Ive not been on here for a while, Over the last month or so I’ve have a lot of the mechanicals overhauled, New front Exhaust to stop a leak, New Brakes and hoses due to wear and leaks, had the Hubs rebuilt and the Swivels replaced, New Choke cable, New rear axel Check straps, replaced the...

Thanks for the comments guys

Thank you, that Is high praise indeed

Thanks for the ideas guys, I don't think the checker plate is for this truck maybe I can get something turned to fit and cap it, I might go to the chandlers and see if they have anything!

Interesting thoughts there Thanks! I will let you know what I decide!

Compressor install now complete, I have two quick connector outlets, one on the rear crossmember and one on the passenger side with the receiver/tank Also have a reg / filter for moisture and to keep an eye on the pressure Not sure what to do next! Will have to give it some thought...

good Man! @Timasmith86 and @jackuar_land_rover if anyone is interested!

Its wired to my second battery which is also mounted on the rear cross member on the other side, Its an ARB compressor that comes with a full wiring harness, so its pretty straight forward, pressure switch and relay are mounted with the compressor, the power and earth are back to my second...

Quick update of recent progress The over spray correction continues... Before: dark green overspray; Next project: Onboard air... Compressor mounted on the rear crossmember in the wheel arch and protected with a mud flap Quick connector mounted on the rear crossmember Switch mounted...

You must all be bored of seeing Teak by now so here are some from todays outing... She is pretty much done now, I've installed some lights inside the storage bit too... out for a drive on a nice winters day! after about 5 mins of being at a pretty quiet beach... what are the...

Metal trim set up for the floor, Storage Floor sanded off and cleaned ready for oil, Oilled and in place One coat on, ready for the second...

Caulking sanded back ready for adjustments for fitment! nearly there! I then decided to use the offcuts i had left over to make a floor for the storage box... slightly different layout to before as i have had to use a smaller boarder, but i think it will still look ok. sanded back...

Thanks Jasper74