Search results

Hi all. My FL1 won't start. a couple of weeks ago it started ok but wouldn't start again when hot, but leave it a few hours and no problems, then it got worse and I'd have to crank it for 5/10 mins on and off before it started, but was a but sluggish under full load. So checked and changed...

thanks again, i'll get the bolts sorted and wing it for the screws, got plenty around, on a different note my FL also came with Land Rover front and top rear light guards (pre facelift) but not fixings, are sets available? i'm guessing just longer screws and some sore of packer for the rears but...

Amazing thanks for the quick reply, can I also ask are there screws onto the bumper?

can anyone tell me what bolts/screws etc i need to fit the under tray. My FL1 was missing it and I've just picked 1 up but no fixings

Any gurus out there who can help. Got an intermittent starting problem, every so often my hippo takes ages of cranking to start, only happens when it's hot, it's almost like fuel evaporation. Any help/ideas Tia

hi is anyone else having problems loging into topix? i can't get in despite changing password (just in case i was putting the wrong one in). i was trying to look at the instructions for parking sensor fitting specifically the placement, and i know i've seen it on topix. I've got a front and rear...

Thanks for all the helpful information, in the end I bit the bullet (and opened the wallet) and dropped the car into a local garage. Just had it back and have other problems!!! The front nearside brakes are squealing like mad and the A/C whines when switched on, neither of these happened before...

thanks nodge68, how do i release lever bush in the box? can it be done without removing the gearbox? the pivot arm is free does that indicate that the bush is already free? i've already replaced the master/slave and slave bracket and am getting stuck

thanks for all you advise, i'll check for fluid leak but pretty sure that's a no as is lack of movement and air in the system. i'll try and take photos/videos tomorrow and wait your advise

Yes the white cap that has tabs that hold the slave in until fitted is on and I didn't unclip the tabs until fitted. And fitted support bracket whilst pushing it to the left,towards engine as per another thread.please keep asking questions as it's doing my nut in!

no didn't touch the cap as it's a sealed unit oem parts on both. when the clutch was working there was loads of bite on it so i don't think it's too worn and i would expect the pedal to be a the top of it's travel if it was worn the release lever does seem to be fully upright with a bit of...

Can anyone help with this problem before I go mad! I've got a 1.8 freelander 1 , it's always had a low biting point on the clutch but last week the hydraulics went, so I changed the master/slave all in one unit and even though I had a pedal still couldn't get in any gear with the engine running...

hi can anyone help, just got my first freelander 1.8 and whilst I've got the propshaft in the boot,there are no bolts! has anyone got the specs of them all or point me to where i can got them.

Evening all, just got my first freelander 1 1.8 3 door 2001. It's in really good nick, under 80,000 miles with a ton of paperwork, but sorry to ask as a first post but........ Anyone with any ideas for my CD multiplayer, it reads that there are discs but doesn't play them. And what bolts do I...