Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. davebaird

    front prop phasing

    Had the front prop off today (defender 90 300tdi) and managed to pick wrong end up which split the prop. Searching on here I know they are phased, holding the prop so it is in phase which way do I turn it, ie 1 tooth anti clock wise or 1 tooth clockwise or is there no difference. It is an...
  2. davebaird

    steering drop arm

    Picked up on last mot excessive play in ball joint, easy enough me thinks, buy tool on internet to help extraction. away we go remove nut, brake taper with two hammers, this is easy. Remove circlip on bottom everything falls out not sure that's supposed to happen. Put in new top cup needed very...
  3. davebaird

    anti-roll bar nut sizes

    Need to replace anti-roll bar bushes and two drop links. Does anybody know the nut size for the bushes, found the size for the drop link as m16 if this is correct, cheers for any help
  4. davebaird

    disco swivel damper

    Rebuilding two disco hub assy's to go onto my defender, the two torx screws in the bottom swiver pin have rounded, so will need to drill out, do I need to put the damper back on or can I just scrap it
  5. davebaird

    disco hubs on a defender

    Have a 95 defender 300tdi, will need to change swivel ball soon, but due to having no drive to park it on , i was thinking of getting hold off hub assy's and rebuilding and then just swapping over. I can get disco 1 locally, searching the forum says the axle is a swap is it the case of the hubs...
  6. davebaird

    passed mot

    :D yipeee passed MOT only 2 advisories, brake discs corroded still stops OK and prop shaft uj worn have one to replace it when the monsoon stops and I can get under her
  7. davebaird

    rear wiper wiring

    Need to install a new rear wiper motor. The old one has the wiring into a round plug, whilst the new one has 2 plugs. Doing a bit of searching I can get the plug not sure about the other plug, a couple of questions 1. are the nut and grommet available separate 2. What order do the wires go to...
  8. davebaird

    Saying hi

    Just joined, had the landy for about 10 months, only done two jobs on her so far, am thinking of buying shares in WD40:)
Back
Top