Feed is 8mm ID and 10mm OD
Return is 6mm ID and 8mm OD.
Nylon air line is cheap and available in those sizes if you need more. Join with...
Valve not seating fully (bent valve head) ?
Lump missing off the cam lobe?
Personally I wouldn't fret over the bracket.
You can't have too many earth's, I've got one direct to one of the starter mounting bolts as well as...
Can you fit them inside?
I got one from vehicle wiring products years ago which came with simple wiring instructions.
Triggered by the door switches .
You don't use a tap to remove a broken anything.
What's actually happened?
Hello and welcome from me too:)
Also, and I'm not sure about this, some Bosch injector pumps have a fine filter located in the inlet port?
My 200 doesn't have one but the 300 might?
Check boost pressure next.
15psi for the 300 iirc.
Hello and welcome from me:)
Terrifying is correct.
I still get cold sweats when I think back to my pan hard rod issue, only doing 30mph and the truck was uncontrollable and...
It mustn't retain water either.
The LR stuff was foil faced that's all I can remember when looking at a breaker at craddocks years ago. I would...
Just looked at your pic better...2mm thick should be ok, weather it does anything is a different matter.
I wouldn't have thought you could get much behind the dash tbh, that's why LR put it on the engine side I should imagine?
The panhard rod play needs doing for sure.
No play in that is critical for your steering.
I fitted the NAS spec ones from paddocks around 14 yrs ago I think. Still got the same bulbs in them. I did have to trim the holes out in the...
[ATTACH] repair pic to show where the mount is.
I had that and it was a missing lower damper bush on the front. On strip down I also found the axle mounting for the damper had gone oval.
Separate names with a comma.