Search results

I replaced complete wish bones and bushings about 3 mos ago I noticed last week a rattle while driving over bumps Always at slower speeds I removed wishbone for inspection and noticed that the inner sleeve of rear bush and worn out enough to rattle on the rear trailing arm of wishbone My...

Hello all Have done lots of reading on here but still have not found answer 2002 td4 auto As title says I have my radiator cooling fans come on and stay on at all times air con is off coolant temp never more than 85 according to icarsoft When a/c is on fans operate properly displaying...

Thanks for reply I’ll keep searching

Curious about the availability of heated freelander 1 wind screens in uk I went to have one replaced in bc Canada and was told no longer available Even through Land Rover dealership. Speedy glass may have to use auto wreckers to source one. But rare at breakers as well.love the car but maybe...

from the looks of your pics,the hose routing i have done is correct i mounted my evo in the same place as factory last night my wife worked to 11pm so i set timer for 10;15pm she said it was very warm immediatly after starting car as compared to without fbh

yes they work well,the td4 putting around town does not create a lot of coolant heat.td5 is a lot better i will be putting one in my disco 2 td5 as well my wife loves the heat in the freelander now brett

looking at rave and the land rover part numbers there is a different hose set up between the fbh and non fbh fbh,part#jhb000160 ,has a one way valve a y pipe and a t for the line that enters fbh(top pipe from matrix).maybe i should have spliced in the exit hose instead of installing the hose...

thanks for replies i would assume it should heat the engine without engine on and water pump circulating coolant if there is someone with a freelander 1 with fbh that could send photos of the coolant lines how they hook up to matrix with i am pretty sure i have it correct but pics may be...

Hell all I installed a webasto that is used as sparking heater in our North American trucking industry today. I used the coolant line set up as per rave for td4 auto It seems that it doesn’t really act as a block heater as it is currently plumbed Does it only focus on the heater matrix Or will...

Thanks ordered one from Portugal I hope that’s the problem my vent appears to be clear Brett

I seen that but currently unavailable As with a lot of vendors

was wondering if there are any replacements or sbstitutes for seal ftc2199 i have a leak around selector shaft and this apparently is part number but getting hard to find. thanks brett

I did not take measurements as I was pressed for time after 3rd time I did notice that on third attempt that the Gearbox slid in easier with the valeo I believe that the borg and beck parts were faulty as it was harder to push gear box up to engine It’s amazing the amount of rabbit holes you...

update took apart for third time removed borg and beck friction and pressure plate installed original valeo friction and pressure plate(were not worn at all anyway) and works perfect mental note dont buy borg and beck stick with valeo brett

Replaced clutch today seems hard to get in 1st and reverse I replaced dmf valeo Friction disk and pressure plate borg and beck Pilot bushing Release bearing and slave It is bled correctly with firm pedal Reason for change was pilot bushing was gon and dmf was on last legs Original Valeo clutch...