All filled up and no leaks so far but will need to drain down again to change the hose joiners in the bottom hose as the only ones I had were a...
Update, radiator fitted and plumbed in, bottom hose was still a bit of an epic fit but got there in the end, modified RR bottom hose a U bend and...
Price looked pretty good and I've used them in the past so I went ahead and ordered it along with a bottom hose to help with the installation,...
Thanks just had a look and it would appear to be a viable unit, wonder why mine has the straight pipe, then again mine seems to have been a bit of...
Thanks for your input but my problem is the shape of the bottom hose stub which points directly at the v belt so there's no space for a bend in...
Here we go, not a lot of room to get a good angle, if the bottom connection was angled down a bit and towards the off side a bit I guess I could...
I'm now at the point where I need a radiator, engine runs after replacement ignition amp fitted, brakes all plumbed up and bled, gearbox tested...
Thanks I'll give that a go. Graham
Always living life on the edge! Sorry about the name spotted the Alan just after I clicked send! Brakes work fine now but looks like the ignition...
Pressure bleeder every time especially when starting from scratch or doing a fluid change, so much easier and pretty fool proof! Graham
All sorted now, problem was a blockage in the banjo connection on the M/C, stripped and cleaned and all good now, tried to loosen the switch but...
Main difference between 86 and 87 seems to be the prv for the rear brakes is different and whether it's the upper or lower pistons in the front...
Hi Tom, yes I saw that in my manual but I think that only applies to pumping the brakes to bleed not with a pressure bleeder, the drivers side...
Been spending the last few days dodging showers to get my brakes plumbed in and bled, all new brake pipes and flexibles fitted to overhauled...
Close but not quite I need the plug on the other end to connect to the wire from the pads, I have one but the other has been lost in the...
The cable I need goes from the plug on the pad leads to the 2 pin RISTS connector on the loom or a source for the connector to go with the plug on...
86/87 Range Rover brakes, I need to replace the connector between the 3 pin RIST connector and the plug on the prake pads as mine have fallen to...
Thanks yes that was what I planned to do unless there was a better solution. Graham
The plastic ball rings a bell, it's a long time since I pulled the engine to build a LR/RR hybrid no A/C lol so I'll just leave it blanked! Thanks...
Separate names with a comma.
