Nodge, thanks for reply. Nothing to lose by trying soldering. It looks as though that was done originally I will post back after giving it a go
[ATTACH] Whilst putting new runners on the tail one of the window heating contacts came unstuck from the window, see left-hand contact on photo....
[ATTACH] [ATTACH] I overcame the problem with a 75mm x 8mm screw on each leg of the runner. See photos
Nodge, thanks for reply Yes, all the seals are in place
[ATTACH] [ATTACH] I installed the new regulator from LR Trade Parts, relatively straight forward job BUT rear window does not go under the top...
See my thread https://www.landyzone.co.uk/land-rover/tail-gate-window-cables-again.376977/ Snap!!
Cables have broken on the tail-gate window on my 2006 FL 1 I've searched the forum, looked at the Youtube videos and the job looks doable :)...
No problem with bearings, just the rubber mounts. I did ask and they could not come up with a reason for failure
To complete this thread: The VCU and support bearings were purchased from Bell Engineering so I gave them a ring re the failing rubber bearing...
I have been getting a noise on my F L 1 facelift similar to the exhaust contacting the bodywork when turning sharp left and right. The weather is...
Ali, thanks for reply, I had a play and everything went back together, having the key in the lock made the difference
I dropped the fuel cap which is now in three pieces! I "think" it should go back together but any advice very welcome apart from don't drop again!!
Andy, thanks for reply and photo, I thought it would be a screw and washers. A photo of the correct fitting will be appreciated, it's a sunny day...
A minor detail but I'd like to get it right. See photos of air inlet duct retaining screws; one is missing and the other is not doing a lot! I am...
Thanks for replies I'll fill the gouge with appropriate colour filler and see what it looks like. If it's a mess I'll replace with a used section...
OK I should have noticed but the post wasn't that high! Anyone have any idea how I can get rid of the deep scratch in the plastic moulding (see...
Fitted Yuasa battery, 76Ah, CCA 680, form Battery Megastore - £64.50 Usual problem with clamp, see photo complete with corroded clamp screw. I...
Thanks for reply, the grommet is in a "impossible" position to get fingers or screwdriver to gradually work it in place. I'm wondering how others...
Removed rear bumper to try and find answer to similar problem to original post , reverse sensors not working. All connectors clean and no...
Thanks all for replies I "cheated" but no one would notice;) Very good idea in Haynes manual to tie string to the "catch" end of the old cable...
Separate names with a comma.
