Order and fit new rear air bags....sorted. Takes about 45 mins per side, with a set of axle stands, a 3 ton trolley jack and 2 cups of tea...:)...
My 2001 disco failed the MOT on anti-roll bar ties and front axle knuckle ball joints last week, I replaced all 4 ball joints and anti-roll bar...
Keith. How much would you want for it???
Not sure maybe someone with more disco knowledge could advise us? I believe mines pre face lift. [ATTACH]
Alive just
Its been a while since I've been here, so out of touch with the forum, life gets in the way at times... I'm in the need of a front plastic bumper...
Have you tried "Foley Specialist Vehicles" near Harlow in Essex......01279. 793500. They build/prepair vehicles for safari, special vehicles,...
What was the batteries voltage before charging?
Platinum batteries have cell plates with calcium in them, your charger needs to have a minimum output voltage of 14.8 volts when charging and...
Does it have a rubber doughnut in the rear propshaft, if so it could be breaking/cracking up. Might be an idea to check your engine and gearbox...
How deep is the scoring in the water pump housing?
If you need to pressure test the cooling system I have a pressure test kit. I'm only a short distance away and work in Sheffield during the week. zzr
1. Radiator could be partly blocked allowing partial flow only (flow test appeared OK), the problem is you need to be able to feel the front of...
Faultmate msv2 extreme the best offering from Blackbox Solutions, expensive not as expensive as the Testbook T4, but defo better than the Testbook.
All steering drop arms are the same no matter what vehicle or model they're fitted too, either they fall off easily or are complete bast**d's.
Loosen and back off the drop arm nut, then use a 2 legged hydraulic puller to apply the pulling force and then shock the drop arm by the taper...
You complaining about it now but once you get used to the vehicle, they do get under your skin and the love affair will start. Mine started many...
50-00 quid with a full fuel tank to get me home......money waiting
I'm fairly sure the handle itself doesn't reads the key code, the lock barrel for the key blade is built from the key blade record that Land...
I took the Range out for a run of about 5 miles on Wednesday after replacing the voltage regulator, I then reset the SRS warning light, so far it...
Separate names with a comma.
