Even if you can manually open it from inside of the tailgate, youll still have to get the window to drop. Unless you have done already? If not,...
From what i read he's already done a freelander or two...
Apparently ZandF can remap the MEMS3 to suit a turbo lump......
Have the draper camshaft pulley locking tool, its a flywheel locking tool ive made but not one that bolts on through the gearbox bolt threads....
If i think about it, the clicking was most likely the tesnioner springing back as the pulley skipped teeth going the other way back to correct timing.
Just been reading the previous posts regarding freelander turbo. Ive been thinkimg about a vvc / turbo hybrid in a freeby for a bit now. Will be...
Had one as my first car, still have cos im a sentimental **** who doesnt get rid though i might be breaking it soon. Only got retired cos i...
I actually have one of those spoilers that someone posted a link to on the rimmer bros site. Theyre sold out because they didnt make that many in...
That red thing (must have been painted by prev owner, never seen a red one before!) in your video, thats the dizzy cap. Pull the leads off taking...
Cheers for the replies guys. Can anyone comment on what the clicking noise might have been while the pulley was turning? It was fairly loud and...
Have put Michelin Lattitude Cross's on my girlfriends freeby and theyre a nice good tyre. Good road handling while great on gravel and decent...
Dont think a dodgy sensor would stop it from starting. Plus, 37 quid for a tps sensor is a right rip off. Ive never heard of them going that...
Could you smell petrol from the plug holes when you took them out? Try taking them out right after cranking and seeing if the plugs are wet at...
Long time no see guys. Half way through replacing the timing belt on the girlfriends freelander 1 (1.8k) and had a bit of a ****up moment. Tried...
So the carb goes back on this morning, same as before. Turns over but won't even attempt to fire. Took a plug out an there's definitely petrol...
Cleaned up the plugs all nice and shiny tonight, put them onto the HT leads and tested one by one for sparks... all were sparking nice and strong....
I've cut a straight slot into the head of the screw before with my dremel and a cut-off wheel. Enables you to get a flathead screwdriver in there...
Measured the HT's with multimeter set to DC with the engine cranking to check for the correct fluctuations.
Agree with Hippo when he says the IRD will be too stressed for a permanent RWD setup. Ever heard of a VCU solidifying causing it to be...
Not sure if points and condenser was changed, will take the dizzy cap off and investigate. If the condenser was gone, that would stop voltage...
Separate names with a comma.
