Datatek
Well-Known Member
- Posts
- 43,918
- Location
- Near Poitiers SW France
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
They did say they had specific P38 diag when I first called because the guy joked about how little they use it. I'll give them a bell tomorrow and confirm they used P38 specific diag and not generic snap-on stuff.
- Posts
- 31,350
- Location
- North Shropshire
What's the deal with egr thingummies? Do you treat them as a service item.. take off and clean periodically even if no active fault?
brianp38dse
Well-Known Member
- Posts
- 19,572
- Location
- heathrow
Pull the hose of that activates the egr and put a bolt in the end, no more egr to worry about
gold rover
Well-Known Member
- Posts
- 10,132
- Location
- Scotland,
Thanks. Just had a look at LR parts , and have to say I won't be using them, despite price being good. I don't use any company that puts a surcharge on Highlands and Islands. There's no need. The courier charge is worked into price. If they use royal mail they don't charge extra.On checking fitment they are not LR but Porsche
These are the correct ones I think, check at bottom. Still 45% off
https://www.eurocarparts.com/brake-discs
These are pretty much the discs me and Piercy have but for L322 full front & back
https://vi.raptor.ebaydesc.com/ws/e...1&pm=1&ds=0&t=1631536812000&ver=0&cspheader=1
- Posts
- 12,126
- Location
- Sud ouest France !
Not a bad price for a full kit reallyOn checking fitment they are not LR but Porsche
These are the correct ones I think, check at bottom. Still 45% off
https://www.eurocarparts.com/brake-discs
These are pretty much the discs me and Piercy have but for L322 full front & back
https://vi.raptor.ebaydesc.com/ws/e...1&pm=1&ds=0&t=1631536812000&ver=0&cspheader=1
- Posts
- 2,427
- Location
- Isle Sheppy
Just checked speed did 10/15 mph no change there traction fault and light on and abs light on also the brake fluid went high after last try so drained bit out then tried again and brake fluid went low do I need to do live data readings on the nanocom thanks for the advice
- Posts
- 31,350
- Location
- North Shropshire
Doesn't that cause issues for a dpf?Pull the hose of that activates the egr and put a bolt in the end, no more egr to worry about
gold rover
Well-Known Member
- Posts
- 10,132
- Location
- Scotland,
Didn't they also make it an MoT fail?
- Posts
- 12,126
- Location
- Sud ouest France !
it depends on the euro rating and cars emissions systems.
On some vw engines around 2004 if the egr valve is blanked the ecu expects the gasses to change as the egr opens. If there is no change in gasses as expected it throws a fault. Earlier models have no recognition of egr gas changes in the final emissions. The later stuff with dpf systems are more sensitive than ever. The latest has an even more complicated emmissions system.....
the thermal engine is dead
RangeRoller dt
Well-Sprung Member
- Posts
- 14,261
- Location
- Trapped inside my head @ LZ asylum
Tempted?Not a bad price for a full kit really
I am
If I weigh my 38 in next week should get most the money I paid for it back.
4.4 V8 with zero mods probably as cheap to run (so I’m trying to convince myself!)
Henry_b
Think outside, no box required.
- Posts
- 15,353
- Location
- somewhere else
Seems the old V8 is píssing coolant out from somewhere, and it is at a very significant rate..
Out of the bellhousing too, so it looks like the entire lump is going to have to come out, oh joy!!
No rush though as its not on the road at the moment.
Out of the bellhousing too, so it looks like the entire lump is going to have to come out, oh joy!!
No rush though as its not on the road at the moment.
- Posts
- 12,126
- Location
- Sud ouest France !
Suicide mate.. Out of the frying pan!!Tempted?
I am
If I weigh my 38 in next week should get most the money I paid for it back.
4.4 V8 with zero mods probably as cheap to run (so I’m trying to convince myself!)
- Posts
- 12,126
- Location
- Sud ouest France !
Oh dear!!Seems the old V8 is píssing coolant out from somewhere, and it is at a very significant rate..
Out of the bellhousing too, so it looks like the entire lump is going to have to come out, oh joy!!
No rush though as its not on the road at the moment.
Datatek
Well-Known Member
- Posts
- 43,918
- Location
- Near Poitiers SW France
No DPF on the P38. I have run one P38 for years with the EGR disabled, no adverse effects to date and no manifold full of crap. The other P38 has been the same for 3 years or so. I reconnect the vacuum pipe for the MOT.
Datatek
Well-Known Member
- Posts
- 43,918
- Location
- Near Poitiers SW France
+1 ^^^^^^^^^^^^^^^^
- Posts
- 12,126
- Location
- Sud ouest France !
Ours is snipped under the manifold out of view but looks connected
no more shïtty manifold gunk
brianp38dse
Well-Known Member
- Posts
- 19,572
- Location
- heathrow
Seems the old V8 is píssing coolant out from somewhere, and it is at a very significant rate..
Out of the bellhousing too, so it looks like the entire lump is going to have to come out, oh joy!!
No rush though as its not on the road at the moment.
Rear coreplug by any chance.
- Posts
- 4,450
- Location
- Rotherham
Update Mark. Son checked bleed nipples and both back ones like me , knackered. So got new ones on order and neighbours gonna have a go at changing them.How did the brakes go our mate?
Henry_b
Think outside, no box required.
- Posts
- 15,353
- Location
- somewhere else
Most likely it seems.
