What did you do with your Range Rover today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Got the washer jets out to try to seal them - lots of water finding it's way through them onto the engine and soaking the bonnet liner.

Took all the leads off the coil pack to take back for exchange tomorrow. Coil pack back on as seemed easier to contemplate in the dry and cold than sleet / rain and cold.
 
Fitted digital voltmeter , to keep an eye on the battery
Here is my volt meter and USB charger installation.
IMG_1242.jpg
 
Gave the MAF another thorough wash through with isopropyl alcohol, fitted the new IACV that arrived today (connector 90 degrees out of orientation but cable reaches and mechanically identical), got the exchange set of plug leads from the garage under warranty and fitted them.
Started first turn of the key and no instability, straight to 1500rpm, climbed to 2000. Checked under bonnet, cruise control cable end had got slightly dislodged, reseated it, revs dropped instantly to idle. Idle stead as a rock at 750ish rpm on the counter, everything quiet, engine the most stable and still we have ever seen it, if it wasn't for the draught from the fan I reckon I could balance a coin on the plenum.
Planning to take for a run later on to see if now happy on the road and lost the hot cutting out / non-starting too.
On to the next task...
Wife currently making some gaskets to reduce / eliminate the water that drips onto the engine through the washer jet mountings.
 
Last edited:
Gave the MAF another thorough wash through with isopropyl alcohol, fitted the new IACV that arrived today (connector 90 degrees out of orientation but cable reaches and mechanically identical), got the exchange set of plug leads from the garage under warranty and fitted them.
Started first turn of the key and no instability, straight to 1500rpm, climbed to 2000. Checked under bonnet, cruise control cable end had got slightly dislodged, reseated it, revs dropped instantly to idle. Idle stead as a rock at 750ish rpm on the counter, everything quiet, engine the most stable and still we have ever seen it, if it wasn't for the draught from the fan I reckon I could balance a coin on the plenum.
Planning to take for a run later on to see if now happy on the road and lost the hot cutting out / non-starting too.
On to the next task...
Wife currently making some gaskets to reduce / eliminate the water that drips onto the engine through the washer jet mountings.

I used roof and gutter sealant on the Jag ones. Tiger Seal is 'enry's sealant of choice.
 
You mean you shoved a bit of old wire down the spade connector and wrapped the other end around the usb connection and wedged it in place with a bit of cardboard? :D the proper landy way :D

There's just about room for one of those spade adapter things on the bottom of the cigarette lighter that allows to to tee off some power. Tight but just possible, on the manual box anyway. I took power for a rear cigarette lighter in the rear ashtray.
 
Back
Top