range rover sports front suspension not going up.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

philip pickard

Active Member
Posts
239
Location
doncaster
hi there ive had trouble with suspension on this rover since i bought it. replacing the compressor, middle block,so now the front suspension not going up back stays up ok. suspension picture on dash keeps flashing from off road to standed when i drive it but thats when suspension is still down at the front. bags look ok no leaks as i can see. im thinking the module may want reprogramimg ?any ideas what to change or look for. didnt think it would be a height sensor but is it worth changing them.thanks in advance.
 
hi there ive had trouble with suspension on this rover since i bought it. replacing the compressor, middle block,so now the front suspension not going up back stays up ok. suspension picture on dash keeps flashing from off road to standed when i drive it but thats when suspension is still down at the front. bags look ok no leaks as i can see. im thinking the module may want reprogramimg ?any ideas what to change or look for. didnt think it would be a height sensor but is it worth changing them.thanks in advance.
Most likely a leaking air bag but the first step is to get the fault codes read.
 
lost signal suspension inactive. i had the codes deleted a while back.because red light was on. but the suspension was all up. the red light has been on for a while again. but now the front doesnt go up ill check for a leak now. dont think its that ha ho ill see thanks
 
Last edited:
codes today c1A20 C1131 UO434 UO132 CAM NOT COMMUNICATING.oh other one thing. car was up and ok every day till we went away and car wasnt touched for 6 weeks, it slowly went down other that time. then when i came to use it again the back came up. but not the front. now both dont move . think i have a small air leak on a pipe from middle valve block. as this was replaced along with new compressor. few months ago.
 
Unless somebody can do codes for the RRS. I can say that those codes for the L322 are. I would think that even LR would use the same codes for different models with the same systems (similar)

There are a few common problems as you can see. Start with the compressor and leaks:).

J
 

Attachments

  • C1A20.pdf
    146 KB · Views: 93
  • C1131.pdf
    150.6 KB · Views: 92
Back
Top