P38A Plenum foam filter replacement

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

domino

Well-Known Member
Posts
2,014
Location
Edinburgh
I know I've seen a guide on doing this... but for the life of me I can't find it!!
Can someone point me in the right direction?

nevermind, as per, found it 5 minutes after posting (after searching for 30 mins)
 
Last edited:
I replaced mine with the original material, however I wrapped it in fly screen first. Looks good and lasts well.
 
Use the foam sandwiched between decent black nylon mesh (eg insect screen) for doors. I'm two years in on mine, and still in good condition, whereas the LR foam lasted about 3 months.
Only other tip, loosen but leave in the top screw on the A pillar seal, the other side can remain in place. The bottom of the seal needs to move to remove the windscreen finisher strip, but the top doesnt. Replace all screws with s.s. and put a blob of rtv on each screw
 
Back
Top