Stiff rear axel

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Funonthefarm

Active Member
Posts
174
Location
Scotland
Just a quick one, any thoughts as to why the rear axel of a 90 td5 would be really stiff, it will roll but with high resistance.

Any ideas would be great, before I have to strip it down!
 
Sorry should have said, the Landy is in bits, full re chassis.... so it’s just the axel on its own.

front is free as anything
 
Tbh can really say, drove fine, would say standing for around 2 months. Both wheels feel about the same to try and rotate by hand.
 
if its just the axle....and it feels fine by hand....could it be you dont have the rear a frame on so its slightly out of alignment?
 
if its just the axle....and it feels fine by hand....could it be you dont have the rear a frame on so its slightly out of alignment?
I think its the axel itself. I took it off to clean up and it was stiff then. I presumed the brakes had bound a little with it sitting. So took the callipers off completely. This did free it up a little but still really hard to rotate by hand. Just wondered if there was anything obvious to look at first before ripping the whole axel apart! Any advice is greatly appreciated.
 
ah sorry i misread. I thought you meant they felt fine bt hand.

I would pull out the drive shafts, that way you can exclude the diff. if its lose without the drive shafts, its the diff, if its the same then you know its either bearings, brakes etc. You might evne find that one is ok and the other not - not sure how it would work with the diff if an issue on one would affect both wheels or not.
 
ah sorry i misread. I thought you meant they felt fine bt hand.

I would pull out the drive shafts, that way you can exclude the diff. if its lose without the drive shafts, its the diff, if its the same then you know its either bearings, brakes etc. You might evne find that one is ok and the other not - not sure how it would work with the diff if an issue on one would affect both wheels or not.
Thanks for the advice, will have a look and see what happens.
 
Back
Top