Series 2 Heater pipework

Please can someone help me out and put up a picture of inside the engine bay that shows the pipework layout that connects the engine to the round smiths heater. I've got the tap on the front of the engine and a small vertical pipe sticking up on the back of the block but nothing in between and no idea what to buy.

TIA Rob

You can make it out of copper/steel tube or reinforced hose.
Pipe from front tap to heater
Pipe from rear of engine by bulkhead to heater.
These run other side of spark plugs.
make sure the tap works before connecting

Hicap phill said:

You can make it out of copper/steel tube or reinforced hose.
Pipe from front tap to heater
Pipe from rear of engine by bulkhead to heater.
These run other side of spark plugs.
make sure the tap works before connecting

Click to expand...

Thanks phil, but either side of the spark plugs?

Marmaduke said:

Thanks phil, but either side of the spark plugs?

Click to expand...

As you look at the motor heater is on passenger side so all the fittings would go past the carb to the heater.
I searched for photos to show route. the S1 does not have a heater
You could use old heater pipes from disco tdi

Std heater hose and copper pipe works well, but check the dia carefully, one size of hose goes over pipe easily, one is really hard. If you find you need a dia hose that slighly loose on the copper cut a yorkshire fitting up and solder it on as a ring.