Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
Did you mix it with the fuel then?Not yet, she's pretty clean anyway, just want to give her the best chance for the MOT emissions test!
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Henry_b
Think outside, no box required.
- Posts
- 15,351
- Location
- somewhere else
yep
RangeRoller dt
Well-Sprung Member
- Posts
- 14,253
- Location
- Trapped inside my head @ LZ asylum
You need good dose with a P38. Amount on back is per tank but most tanks are not 100L
Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
I used to squirt it neat into a "gummed-up" carb. Certainly cleaned out a load of crap!
RangeRoller dt
Well-Sprung Member
- Posts
- 14,253
- Location
- Trapped inside my head @ LZ asylum
I use it now and again if I know I have a long journey. Fuel seems to have these cleaning agents in it in copious amounts as standard these days
- Posts
- 31,261
- Location
- North Shropshire
Does data from the o2 sensors, along with fuel trim give any clue if you'll pass emissions? I'm guessing if you're like me and don't have any cats it won't help
Henry_b
Think outside, no box required.
- Posts
- 15,351
- Location
- somewhere else
02 sensors are fine, thank god!
replaced them a while ago IIRC.
She has the 2 cats from factory one per bank, and they're pucker!!
I'll be sure to give some throttle action on the way there
For the last MOT i had the manifolds glowing red, a proper clean out that was!,
RangeRoller dt
Well-Sprung Member
- Posts
- 14,253
- Location
- Trapped inside my head @ LZ asylum
- Posts
- 31,261
- Location
- North Shropshire
They make a right mess on the lawn!!
No catalytic converters in the landy exhaust either
Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
When my MOT is being "done", on unleaded won't pass emissions threshold, but on LPG, she's as clean as a whistle. If you arrive at MOT running on LPG, that's what they'll test it on when hooked-up to DVLA on computer. This afternoon's bit of useless info for y'all!
kds
Well-Known Member
- Posts
- 2,217
- Location
- old,ugly, tired in Lincoln.
Why ?
Henry_b
Think outside, no box required.
- Posts
- 15,351
- Location
- somewhere else
The LPG system Slaves off the petrol injection system, so if it isn't running right on Pez, then it on't be quite right on LPG either.
Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
I follow the logic, but, at MOT station, it failed on petrol, flipped the switch to LPG and it passed with flying colours.
stuu
Well-Known Member
- Posts
- 1,865
- Location
- Aberdeenshire
Sides off top of dash off took binicale out.
Slight pull on the temp gauge. It was noticable closer to the dial backing compared to the rest.
Pulled needle out slightly on the shaft
Clipped back together and back in.
I know the gauge is never that accurate as its buffered to display without moving about and being as bmw as it is it probably wont move until it's over 105°
But it was annoying
Slight pull on the temp gauge. It was noticable closer to the dial backing compared to the rest.
Pulled needle out slightly on the shaft
Clipped back together and back in.
I know the gauge is never that accurate as its buffered to display without moving about and being as bmw as it is it probably wont move until it's over 105°
But it was annoying
Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
Always nice to improve annoying stuff like that. STILL haven't got round to silencing the screechy brake pedal spring-a-ling though.
stuu
Well-Known Member
- Posts
- 1,865
- Location
- Aberdeenshire
My first p38 red auto had a squeaky brake pedal it was so annoying.
The 2 manual ones always had a clutch noise that was annoying.
Ended up putting a black bag in the foot well and spraying spray grease for fun
Jon Dor
Well-Known Member
- Posts
- 1,672
- Location
- Beverley, East Riding of Yorkshire
I like idea of bin bag... I've taken the kick panel" trim off, but my back/neck/shoulder/elbow and itchy nose makes it difficult to get to the root of the problem. Adding a placcy bag into equation may just work...stopping my nose itching!
stuu
Well-Known Member
- Posts
- 1,865
- Location
- Aberdeenshire
The bag was only so I didn't fully get it over the carpet. Lent up and sprayed heaps on everything that moved. It worked haha
